Xiangfeng Lin

Xiangfeng Lin

Auto-generated profile, based on publicly available information

Xiangfeng Lin

Key Laboratory of Automobile Materials (Jilin University)

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 January 2018 in Advances in Materials Science and Engineering
Verified
Journal Article
Open access
PDF file
XLXiangfeng Lin
Xiangfeng Lin
YLYi Li
Yi Li
ZCZhongyi Cai
Zhongyi Cai
JLJicai Liang
Jicai Liang
CLCe Liang
Ce Liang
YLYanfei Liao
Yanfei Liao
Aiming at the flexible 3D stretch bending with multipoint dies for the aluminum profile, the numerical simulation analysis of the bending process was carried out by ABAQUS finite element software. In the multipoint stretch bending (MPSB) process, the influence of the number of die units on the springback for the complex section profile was studied. The shape error between the forming parts and the target parts was reduced through the method of die surface modification. The results showed that the springback of the aluminum profile could reach a minimum when the number of die units was 25 under the precondition of saving cost and ensuring the quality of forming parts. In the numerical simulation, the maximum shape error of the forming parts reduced from 18.824 mm to 2.456 mm; in the test, the maximum shape error reduced from 27.26 mm to 6.03 mm through the method of die surface modification.

15 October 2019 in Advances in Materials Science and Engineering
Verified
Journal Article
Open access
PDF file
YLYi Li
Yi Li
Ce LiangCe Liang
Ce Liang
XLXiangfeng Lin
Xiangfeng Lin
JLJicai Liang
Jicai Liang
ZCZhongyi Cai
Zhongyi Cai
FTFei Teng
Fei Teng
The springback is one of the main defects in the flexible 3D stretch-bending process. In this paper, according to the orthogonal design of experiments, the numerical simulation analysis of the springback for the 3D stretch-bending aluminum profile is carried out by the ABAQUS finite element software. And to investigate the effect of material properties on the springback, the range analysis of the orthogonal experiment is performed. The results show that these material properties of the aluminum profile (elastic modulus E, yield strength σy, and tangent modulus E1) might have the biggest influence on the springback of the aluminum profile, and the optimized forming parameters are founded as follows: the horizontal bending degree is 14°, the vertical bending degree is 14°, the number of multipoint stretch-bending dies is 10, the friction coefficient is 0.15, and aluminum alloy grade is 6063. Moreover, the model of the BP neural network for the prediction of the springback is established and trained based on the orthogonal experiment, and the results with the BP neural network model are in good agreement with experimental results. So it is obvious that the BP neural network could predict effectively the springback of 3D multipoint stretch-bending parts.