Zinc oxide (ZnO) is a strong luminescent material, as are several polymers. These two materials have distinct drawbacks and advantages, and they can be combined to form nanostructures with many important applications, e.g., large-area white lighting. This paper discusses the origin of visible emission centers in ZnO nanorods grown with different approaches. White light emitting diodes (LEDs) were fabricated by combining n-ZnO nanorods and hollow nanotubes with different p-type materials to form heterojunctions. The p-type component of the hybrids includes p-SiC, p-GaN, and polymers. We conclude by analyzing the electroluminescence of the different light emitting diodes we fabricated. The observed optical, electrical, and electro-optical characteristics of these LEDs are discussed with an emphasis on the deep level centers that cause the emission.
We investigated the influence of the pH value, precursor concentration (C), growth time and temperature on the morphology of zinc oxide (ZnO) nanostructures. The pH of the starting solution was varied from 1.8 to 12.5. It was found that the final pH reaches an inherent value of 6.6 independently of the initial pH solution. Various ZnO structures of nanotetrapod-like, flower-like, and urchin-like morphology were obtained at alkaline pH (8 to 12.5) whereas for pH solution lower than 8 rod-like nanostructures occurred. Moreover, we observed the erosion of the nanorods for a pH value less than 4.6. By changing the concentrations the density and size were also varied. On going from a high ( mM) to lower ( mM)C, the resulted ZnO nanostructures change from a film to nanorods (NRs) and finally nanowires (NWs). It was also found that the length and diameter of ZnO NRs follow a linear relation with time up to 10 hours, above which no further increase was observed. Finally the effect of growth temperature was seen as an influence on the aspect ratio.
1 November 2012 in Journal of Physics and Chemistry of Solids
We demonstrate hydrothermal synthesis of coral-like CuO nanostructures by selective growth on ZnO nanorods (NRs) at low temperatures. During the hydrothermal processing the resulting hydroxylated and eroded surface of ZnO NRs becomes favorable for the CuO nanostructures growth via oriented attachments. Heterojunction p–n diodes fabricated from the CuO/ZnO nanocorals (NCs) reveal stable and high rectification diode properties with a turn-on voltage of ∼1.52 V and a negligible reverse current. The humidity sensing characteristics of the CuO/ZnO NC diodes exhibit a remarkable linear (in a semilogarithmic scale) decrease in the DC resistance by more than three orders when the relative humidity is changed from 30–90%. The NC humidity sensor is also found to reveal the highest sensitivity factor of ∼6045 among available data for the constituent materials and a response and recovery time of 6 s and 7 s, respectively.
We demonstrate white light luminescence from ZnO-organic hybrid light emitting diodes grown at on flexible plastic substrate by aqueous chemical growth. The configuration used for the ZnO-organic hybrid white light emitting diodes (WLEDs) consists of a layer of poly (9, 9-dioctylfluorene) (PFO) on poly (3, 4-ethylenedioxythiophene) poly (styrenesulfonate) coated plastic with top ZnO nanorods. Structural, electrical, and optical properties of these WLEDs were measured and analyzed. Room temperature electroluminescence spectrum reveals a broad emission band covering the range from 420 to 750 nm. In order to distinguish the white light components and contribution of the PFO layer we used a Gaussian function to simulate the experimental data. Color coordinates measurement of the WLED reveals that the emitted light has a white impression. The color rendering index and correlated color temperature of the WLED were calculated to be 68 and 5800 K, respectively.