Asmma Shawqy Khaleel

Asmma Shawqy Khaleel

Auto-generated profile, based on publicly available information

Asmma Shawqy Khaleel

Department of Physics, College of Science, University of Baghdad, Baghdad, Iraq

Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
15 June 2021 in Current Nanoscience
Verified
Journal Article
Open access
PDF file
NAnadia abbas ali
nadia abbas ali
AAAlaa Abd-Elnaiem
Alaa Abd-Elnaiem
SHSeenaa I. Hussein
Seenaa I. Hussein
AKAsmaa Sh. Khalil
Asmaa Sh. Khalil
HAHatem Alamri
Hatem Alamri
HAHasan Assaedi
Hasan Assaedi
Objective: In this work, graphene (Gr) or/and Cu particles are used to improve the thermal and mechanical properties of epoxy resin. Methods: Various contents of Gr powder (0.1, 0.3, and 0.5 wt%), and Cu powder (10, 30, and 50 wt%) were loaded to epoxy to form Gr/epoxy and Cu/epoxy composites, respectively. In addition, hybrids epoxy/Cu/Gr samples were prepared with a selection of the lowest (0.1 and 10) and the highest (0.5 and 50) ratios of Gr, and Cu, respectively. Results: The thermal conductivity increased with the increasing weight ratio of Gr and Cu as compared to the pure epoxy. The thermogravimetric analysis (TGA) of epoxy composites and hybrid composites revealed an improvement in the thermal stability. In addition, the mechanical properties such as hardness shore D and the wear resistance were enhanced for both the epoxy composites and hybrids composites. However, the Ep+0.5wt%Gr+50wt%Cu hybrid composite was found to have the maximum hardness 84, with the thermal conductivity of 3.84 W/m.K. It showed the lowest wear resistance 2.7×10-6 mm3/Nm at loading 10 N. Conclusion: The hybrid composite containing 0.5wt%Gr and 50wt%Cu shows the maximum hardness and thermal conductivity, as well as the lowest wear resistance when compared to other composites. The physical properties of the hybrid composite can be controlled by the host blend, and hence the morphology, and interfacial characteristics.

25 May 2022 in Iraqi Journal of Science
Verified
Journal Article
Open access
PDF file
AKAsmma Shawqy Khaleel
Asmma Shawqy Khaleel
Using three-point bending experiments, the effect of the particle size of SiO2 on the flexural properties of epoxy composites was investigated. Young modulus and flexural strength were studied for different weight percentage of filler (2,4,6,8 and 10) wt%.The size of SiO2 particles varied from micro (100um) to nano (12nm) . Flexural strength and Young modul were found to increase with the filler content, but when the particle size decreased to the nanoscale, the Young module increased. Flexural strength was higher for microcomposites than nanocomposites.