30 June 2025 in Neft i Gaz
SES. Yessenov Caspian State University of Technologies and Engineering
S. Yessenov Caspian State University of Technologies and Engineering
IAINSTITUTE OF OIL AND GAS OF THE MINISTRY OF SCIENCE AND EDUCATION OF THE REPUBLIC OF AZERBAIJAN
INSTITUTE OF OIL AND GAS OF THE MINISTRY OF SCIENCE AND EDUCATION OF THE REPUBLIC OF AZERBAIJAN
The article discusses one of the methods of increasing the efficiency of additional development of facilities and intensification of oil production. Under these conditions, work is underway to eliminate the predominant filtration of the injected water into the most permeable layers or zones. The basic principle of such work is to create an impenetrable or low-permeability barrier in the way of water filtration. This leads to a redistribution of filtration flows, the involvement of stagnant and poorly drained zones in the development, and contributes to an increase in oil recovery. The results of an experimental study of the effectiveness of the use of CS based on a 0,2% solution of polyacrylamide (PAA) and a 3% solution of diesel-alkaline waste (DRL) to increase oil recovery in layered heterogeneous formations are presented. The main attention is paid to the influence of the degree of waterlogging of the produced products and the pressure drop on the oil recovery coefficient (DEEP). The research was carried out on a laboratory model of a reservoir saturated with oil from the Bibieybat field at various levels of waterlogging. (50%, 70%, 100%) and pressure drops (0,003–0,022 MPa). It has been established that pumping CS into a highly permeable layer provides an increase in CIN due to the redistribution of filtration flows and the involvement of low-permeable zones in the development. The highest efficiency was achieved with the early application of CS (DEEP up to 0,805), whereas with complete watering, the indicator decreases to 0,655. It is shown that as the pressure drop increases, the efficiency of CS decreases, but even in extreme conditions, the technology retains a positive effect. Special attention is paid to statistical data processing using sequential Wald analysis, which made it possible to minimize the number of experiments while maintaining the reliability of the results. The optimal average value of DEEP (0,69) was determined for conditions of 70% water availability with an accuracy of 3,18%.
5 December 2024 in Горный журнал Казахстана
Мұнай кен орындары көп жағдайда олардың құрылымы бойынша біртекті емес қабаттардан түзіледі, бұл олардың жоғары қалдық мұнаймен қанығуын анықтайды. Сондықтан мұндай қабаттардан мұнай өндіруді арттыру қажеттілігі туындайды. Эксперименттік зерттеулер жүргізу үшін белгілі бір фракцияның кварц құмымен толтырылған екі металл құбырдан тұратын модель қолданылды. Бұл әртүрлі өткізгіштік қабаттарын алуға мүмкіндік береді. Бұл модельде біртекті емес қабат мұнай өндіруді арттырудың ұсынылған әдісін зерттеді. Бұл жағдайда біртекті емес қабаттың мұнай өндірісін арттыру үшін полимер ерітіндісін айдауды қолдану ұсынылады. Сарқылған қабатты алу үшін бастапқыда біртекті емес шамамен бірдей дәрежесі бар (Ко=К1/К2) қабатты біртекті емес қабатта әдеттегі сулану жүзеге асырылды In most cases, oil fields are structurally formed by heterogeneous layers, which determine their high residual oil saturation. Therefore, there is a need to intensify oil production from such reservoirs. To conduct experimental studies, a model consisting of two metal pipes filled with quartz sand of a certain fraction was used. This makes it possible to obtain layers of different permeability. Using this model of a layered heterogeneous formation, the proposed method for intensifying oil production was studied. In this case, the use of polymer solution fringing is proposed to increase the oil recovery of a layered heterogeneous formation. In order to obtain a depleted formation, the usual flooding was initially carried out in a layered heterogeneous formation with approximately the same degree of heterogeneity (Co = K1/K2) Нефтяные месторождения в большинстве случаев по своей структуре образованы неоднородными слоями, которые и определяют их высокую остаточную нефтенасыщенность. Поэтому возникает необходимость в интенсификации добычи нефти из таких пластов. Для проведения экспериментальных исследований была использована модель, состоящая из двух металлических труб, заполненных кварцевым песком определенной фракции. Это позволяет получать пласты разной проницаемости. На данной модели слоисто-неоднородного пласта изучали предлагаемый способ интенсификации добычи нефти. В данном случае для увеличения нефтеотдачи слоисто-неоднородного пласта предлагается применение оторочки раствора полимера. С целью получения истощенного пласта первоначально осуществили обычное заводнение в слоисто-неоднородном пласте с примерно одинаковой степенью неоднородности (Ко=К1/К2)
30 October 2026 in Neft i Gaz
Increasing the coefficient of oil recovery (KIN) from mature and hard-to-recover deposits remains one of the most urgent tasks of the oil and gas industry in the context of depletion of traditional reserves and an increase in the share of residual oil. A significant part of the residual oil is retained in the porous medium by capillary forces, high interphase activity and unfavorable wetting of the rock. Traditional flooding methods demonstrate limited effectiveness, which stimulates the development of chemical methods to enhance oil recovery, in particular technologies based on surfactants (surfactants) and foam systems. The purpose of this review study is to systematize and critically analyze modern scientific data on the mechanisms of action of surfactants and foam systems, identify scientific gaps and substantiate the prospects for an integrated approach to improving the efficiency of oil displacement. The analysis was based on peer-reviewed scientific articles and highly rated article reviews, mostly based on laboratory work. The article provides a comparative analysis of data and tables by parameters, and an integrated circuit of mechanisms is compiled. The results of laboratory studies were compared and the influence of reservoir conditions was assessed. The results of the study showed that the maximum mobilization of residual oil is achieved through the synergistic action of several mechanisms. It has been studied that, based on the synergistic effect, the total volume of chemical reagents injected into the reservoir decreases, and, as a result, the environmental burden decreases with a decrease in the risk of contamination of reservoir waters. The analysis revealed that, depending on the system and conditions, the increase in additional oil recovery increased from 6% to 33%. The results obtained and the systematized data are recommended for use in pilot projects and scientific research on optimizing the surfactant composition.
30 October 2026 in Neft i Gaz
The study analyzed the mechanisms by which interfacial tension, wettability, and phase mobility affect the efficiency of oil displacement. The relationship between the reduction in interfacial tension and the increase in the capillary number was examined. In addition, the significance of the interfacial properties of oil in the event of oil spills in the Caspian Sea was analyzed. It was demonstrated that polymer flooding primarily increases the reservoir sweep efficiency by controlling water mobility, whereas surfactants and ASP systems mainly affect interfacial processes and residual oil saturation. Natural surfactants and biosurfactants, including sophorolipids with surfaceactive properties and potential environmental acceptability, were identified as promising approaches. A comprehensive approach was proposed that involves the combined investigation of interfacial tension, wettability, rheological and emulsification properties of Caspian crude oils, followed by the integration of the obtained data into reservoir simulation and oil-spill monitoring systems.
25 June 2026 in Neft i Gaz
The article considers the influence of seawater and surfactants on interfacial processes in the “oil–water–rock” system and their impact on oil displacement efficiency under the conditions of the Kashagan carbonate reservoirs. The relevance of the study is associated with the high salinity of formation waters, complex thermobaric conditions, heterogeneity of carbonate rocks, and the need to improve the oil recovery factor in the oil fields of the Kazakhstan sector of the Caspian Sea. The study analyzes changes in interfacial tension, rock wettability, residual oil saturation, and oil recovery factor during the application of formation water, seawater, and chemically modified seawater containing anionic surfactants. Experimental studies were carried out using a DSA100 automatic tensiometer by the pendant drop method under conditions close to the reservoir parameters of the Kashagan field. The results showed that the use of seawater leads to a reduction in interfacial tension and partial alteration of carbonate rock. The most pronounced effect was observed with the addition of surfactants, which ensured the reduction of interfacial tension to ultra-low values and promoted the transition of the reservoir surface from a hydrophobic state to a mixed-wet or predominantly hydrophilic condition.
30 June 2023 in Neft i Gaz
B«BRANCH OF LLP «KMG ENGINEERING» «KAZNIPIMUNAIGAS»
BRANCH OF LLP «KMG ENGINEERING» «KAZNIPIMUNAIGAS»
+3