Nuclear reaction rates become nonlinear with respect to flux (cm−2s−1) in extreme environments such as those found during stellar nucleosynthesis and terrestrial nuclear detonations. To observe these effects directly in the laboratory, extremely high particle fluences (cm−2) are necessary but not sufficient. Reactor-based neutron sources, such as the Institut Laue-Langevin’s high-flux neutron reactor, were previously the closest to meeting this challenge, albeit over ∼hour time scales. In ultra-high flux environments, where multiple reactions occur on picosecond time scales, nuclei are unable to return to their ground states between reactions; consequently, reactions take place on excited nuclei. To accurately model high-flux environments, data on the cross-sections of excited nuclear states are required, which differ significantly from those of ground states due to spin/parity effects. In order to replicate these effects in the laboratory, short high-fluence pulses on the order of the lifetime of a typical nuclear excited state (generally ≲1 ns) are required. Particle beams generated by high-intensity lasers are uniquely positioned to meet this need with the potential to produce fluences of 1017 protons/cm2 and 1022 neutrons/cm2 over a few pico-seconds or less. In addition to providing a quantitative analysis of the rates of multiple rapid reactions in general, the present work examines a number of laser-based experiments that could be conducted in the near future to observe multiple rapid reactions for laboratory-based astrophysics and the measurement of exotic cross-sections.
This work presents the results of a nuclear fission experiment with depleted uranium, driven by ultra-intense multi-MeV bremsstrahlung, generated by laser-accelerated electrons in a high-Z converter, which enables the production of radioisotopes on the picosecond timescale. The advanced plasma target made of pre-ionized low-density foam enabled effective electron acceleration to energies of up to 100 MeV at a laser intensity of 1019 W cm−2 and the generation of ultra-bright bremsstrahlung with an effective temperature of 11.8 MeV in the giant dipole resonance region, with a previously unattained high conversion efficiency of 1%–2%. A major hazard in high-power laser experiments is the presence of harmful radiation and its impact on sensitive detectors. A gas flow system was used to transport volatile fission products from the laser-target interaction point to remote detectors in under ten seconds. This spatial separation of the detectors from the point of laser-matter interaction significantly reduces background noise, the impact of harmful radiation, and enables the detection of signals from short-lived radioisotopes—the products of induced nuclear fission—with high sensitivity.
16 May 2023 in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment