1 September 2020 in Journal of Instrumentation
21 September 2020 in Physical Review Letters
This Letter describes a search for narrowly resonant new physics using a machine-learning anomaly detection procedure that does not rely on signal simulations for developing the analysis selection. Weakly supervised learning is used to train classifiers directly on data to enhance potential signals. The targeted topology is dijet events and the features used for machine learning are the masses of the two jets. The resulting analysis is essentially a three-dimensional search , for , and , are reconstructed as large-radius jets, without paying a penalty associated with a large trials factor in the scan of the masses of the two jets. The full run 2 collision dataset of recorded by the ATLAS detector at the Large Hadron Collider is used for the search. There is no significant evidence of a localized excess in the dijet invariant mass spectrum between 1.8 and 8.2 TeV. Cross-section limits for narrow-width , , and particles vary with , , and . For example, when and , a production cross section between 1 and 5 fb is excluded at 95% confidence level, depending on . For certain masses, these limits are up to 10 times more sensitive than those obtained by the inclusive dijet search. These results are complementary to the dedicated searches for the case that and are standard model bosons.
13 August 2020 in The European Physical Journal C
A search for direct pair production of scalar partners of the top quark (top squarks or scalar third-generation up-type leptoquarks) in the all-hadronic $$t{\bar{t}}$$ plus missing transverse momentum final state is presented. The analysis of 139 $$\hbox {fb}^{-1}$$ of $${\sqrt{s}=13}$$ TeV proton–proton collision data collected using the ATLAS detector at the LHC yields no significant excess over the Standard Model background expectation. To interpret the results, a supersymmetric model is used where the top squark decays via $${\tilde{t}} \rightarrow t^{(*)} {\tilde{\chi }}^0_1$$ , with $$t^{(*)}$$ denoting an on-shell (off-shell) top quark and $${\tilde{\chi }}^0_1$$ the lightest neutralino. Three specific event selections are optimised for the following scenarios. In the scenario where $$m_{{\tilde{t}}}> m_t+m_{{\tilde{\chi }}^0_1}$$ , top squark masses are excluded in the range 400–1250 GeV for $${\tilde{\chi }}^0_1$$ masses below 200 GeV at 95% confidence level. In the situation where $$m_{{\tilde{t}}}\sim m_t+m_{{\tilde{\chi }}^0_1}$$ , top squark masses in the range 300–630 GeV are excluded, while in the case where $$m_{{\tilde{t}}}< m_W+m_b+m_{{\tilde{\chi }}^0_1}$$ (with $$m_{{\tilde{t}}}-m_{{\tilde{\chi }}^0_1}\ge 5$$ GeV), considered for the first time in an ATLAS all-hadronic search, top squark masses in the range 300–660 GeV are excluded. Limits are also set for scalar third-generation up-type leptoquarks, excluding leptoquarks with masses below 1240 GeV when considering only leptoquark decays into a top quark and a neutrino.
1 October 2020 in Physics Letters B
1 May 2024 in Journal of Instrumentation
The ATLAS detector is installed in its experimental cavern at Point 1 of the CERN Large Hadron Collider. During Run 2 of the LHC, a luminosity of ℒ = 2 × 1034 cm-2 s-1 was routinely achieved at the start of fills, twice the design luminosity. For Run 3, accelerator improvements, notably luminosity levelling, allow sustained running at an instantaneous luminosity of ℒ = 2 × 1034 cm-2 s-1, with an average of up to 60 interactions per bunch crossing. The ATLAS detector has been upgraded to recover Run 1 single-lepton trigger thresholds while operating comfortably under Run 3 sustained pileup conditions. A fourth pixel layer 3.3 cm from the beam axis was added before Run 2 to improve vertex reconstruction and b-tagging performance. New Liquid Argon Calorimeter digital trigger electronics, with corresponding upgrades to the Trigger and Data Acquisition system, take advantage of a factor of 10 finer granularity to improve triggering on electrons, photons, taus, and hadronic signatures through increased pileup rejection. The inner muon endcap wheels were replaced by New Small Wheels with Micromegas and small-strip Thin Gap Chamber detectors, providing both precision tracking and Level-1 Muon trigger functionality. Trigger coverage of the inner barrel muon layer near one endcap region was augmented with modules integrating new thin-gap resistive plate chambers and smaller-diameter drift-tube chambers. Tile Calorimeter scintillation counters were added to improve electron energy resolution and background rejection. Upgrades to Minimum Bias Trigger Scintillators and Forward Detectors improve luminosity monitoring and enable total proton-proton cross section, diffractive physics, and heavy ion measurements. These upgrades are all compatible with operation in the much harsher environment anticipated after the High-Luminosity upgrade of the LHC and are the first steps towards preparing ATLAS for the High-Luminosity upgrade of the LHC. This paper describes the Run 3 configuration of the ATLAS detector.
1 November 2016 in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment