Juan Pedro Ferrer Gutiérrez

Juan Pedro Ferrer Gutiérrez

Auto-generated profile, based on publicly available information

Juan Pedro Ferrer Gutiérrez

Universidad Tecnica de Machala

Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
19 March 2024 in Acta Agronomica
Verified
Journal Article
Open access
PDF file
TIThalía Gabriela Vera Infante
Thalía Gabriela Vera Infante
JGJuan Pedro Ferrer Gutiérrez
Juan Pedro Ferrer Gutiérrez
KYKATTY ALEXANDRA GADVAY YAMBAY
KATTY ALEXANDRA GADVAY YAMBAY
STSUSANA ELIZABETH BLACIO TORO
SUSANA ELIZABETH BLACIO TORO
FCFabián Patricio Cuenca-Mayorga
Fabián Patricio Cuenca-Mayorga
In this study, adsorbent materials prepared from common wastes generated in agricultural industries were evaluated, particularly the adsorption capacity for hydrocarbon compounds. Wastes from banana, cocoa, and rice were collected, and subsequently dried, milled, and chemically treated with NaOH. The physical properties of the treated wastes were assessed, including buoyancy and apparent density, and their adsorption capacity was tested under dynamic and static conditions. The results were subjected to an analysis of variance (ANOVA). The dynamic adsorption tests carried out indicated that the treated waste from banana leaves with a particle size of 1400 µm exhibited a buoyancy percentage above 90 % in the hydrophilic phase, while hydrocarbon compounds were adsorbed in the oleophilic phase. However, traces of hydrocarbons were still visible in the aqueous medium. In the short-term static adsorption tests, the waste materials showed adsorption capacity values ranging from 2.17 to 8.22 g oil/g adsorbent for motor oil; the highest adsorption index was determined in wastes from banana rachis with an 850 µm particle size. Moreover, in the adsorption of diesel and gasoline, the wastes from banana rachis with an 850 µm particle size showed the highest adsorption capacity for diesel (6.61 g diesel/g adsorbent) and gasoline (6.26 g gasoline/g adsorbent). This behavior was also observed in the long-term tests for all wastes tested, except for banana rachis, as some of the adsorbent material subsided, leading to the adsorption of both water and hydrocarbon compounds.

1 January 2021 in Revista Colombiana de Química
Verified
Journal Article
Open access
PDF file
JFJuan Pedro Ferrer-Gutiérrez
Juan Pedro Ferrer-Gutiérrez
JSJovanny Angelina Santos-Luna
Jovanny Angelina Santos-Luna
JPJhonny Édgar Pérez-Rodríguez
Jhonny Édgar Pérez-Rodríguez
JMJefferson Michael Marcheno-Revilla
Jefferson Michael Marcheno-Revilla
FCFabián Patricio Cuenca-Mayorga
Fabián Patricio Cuenca-Mayorga
Agave cocui vinasse was physicochemically characterized with reference to the relevant environmental regulations. The following results were obtained: COD: 71,000 mg.L-1, total solids: 21,000 mg.L-1, dissolved solids: 17,000 mg.L-1; pH: 4.06, conductivity: 9.45 mhoscm(-1), total Fe: 48.83 mg.L-1, total phenols: 8.66 mg.L-1; BOD: 30,000 mg.L-1. Fenton and photo-Fenton reactions were applied to treat the wastewater produced. For the Fenton process, the optimal oxidation conditions found were pH = 3.48, [COD]:[H2O2] mass ratio = 1:5, and [Fe+2]: [H2O2] mass ratio = 1:6. For the photo-Fenton process, the optimal parameters found were: pH = 3.98, [COD]:[H2O2] = 1:7.86, and [Fe+2]: [H2O2] = 1:5. The experimental data were adjusted to fit second order polynomial models with R-2 = 0.88 for the Fenton process and R-2 = 0.91 for the photo-Fenton process, respectively. The sludge produced featured the following characteristics: average COD: 41,000 mg.L-1, total Fe: 296,000 mg.L-1, pH: 7.7. The variables with the greatest influence in both processes were [Fe+2]:[H2O2] and [COD]:[H2O2].