The first velocity correction is used to correct the measured distance affected by the velocity variation of the electromagnetic wave propagation in a medium. This correction depends on the refractive index of the propagation medium and reference refractive index. The influence of the temperature in the medium refractive index is critical; some estimates establish that variation 1°C causes 1ppm of error in distances. In the measuring processes with total stations, the temperature is usually collected at only one point, for example, in the position where the measuring instrument is setup. However, the wave propagates in a medium of non-constant temperature, where the extremes of the line can present variations and thus this measurement in only one point could be non-representative. In this context, it was developed a low-cost real-time temperature acquisition system. This system provides the temperature values in different locations allowing their monitoring through the time. Experiments realized during the geodetic monitoring of a dam, show variations up to 8°C among geodetic points on the dam and around it. An analysis was development to evaluate the influence of temperature variations on monitoring distances and geodetic coordinate of a 2d network with different approaches (temperature modeling). The results shows different values for distances (1.0 mm) and coordinates (0.5 mm) depending of the approach choose.
3D printing technology has revolutionized many design practices with the possibility of generating perfectly functional prototypes or parts in many areas of knowledge, such as Cartography. Different types of cartographic products made by these productive methods can be found in the literature. However, a very small number of researches address the scientific question of what this 3D cartographic production process really works in terms of cartographic communication, nor is it discussed about this new way of approaching tangible cartographic products. This article presents the concepts of 3D printing applied to Cartography and theoretical-conceptual examples on the use of three-dimensional modeling combined with additive manufacturing in the generation of cartographic products. The advantages of 3D printing are presented, such as visualization, production time, use of different materials for various products, which were previously difficult to produce, in addition to the possibility of generating new forms of representation. Elements that still need further research are highlighted, such as symbolization, generalization applied to three-dimensional geometric models, the use of colors in 3D printing and texts and toponyms.
Global pose refinement is a significant challenge within Simultaneous Localization and Mapping (SLAM) frameworks. For LIDAR-based SLAM systems, pose refinement is integral to correcting drift caused by the successive registration of 3D point clouds collected by the sensor. A divergence between the actual and calculated platform paths characterizes this error. In response to this challenge, we propose a linear, parameter-free model that uses a closed circuit for global trajectory corrections. Our model maps rotations to quaternions and uses Spherical Linear Interpolation (SLERP) for transitions between them. The intervals are established by the constraint set by the Least Squares (LS) method on rotation closure and are proportional to the circuit’s size. Translations are globally adjusted in a distinct linear phase. Additionally, we suggest a coarse-to-fine pairwise registration method, integrating Fast Global Registration and Generalized ICP with multiscale sampling and filtering. The proposed approach is tested on three varied datasets of point clouds, including Mobile Laser Scanners and Terrestrial Laser Scanners. These diverse datasets affirm the model’s effectiveness in 3D pose estimation, with substantial pose differences and efficient pose optimization in larger circuits.