1 August 2023 in Energy & Environmental Science
Multiscale defect structures driven by interstitial Cu, off-centered Pb and Se atoms and scarce anion vacancies in the new CuxPb(Se0.8Te0.2)0.95 give a record-high average ZT among all polycrystalline n-type thermoelectric materials due to high PF.
26 October 2022 in Advanced Science
Realizing high average thermoelectric figure of merit (ZTave) and power factor (PFave) has been the utmost task in thermoelectrics. Here the new strategy to independently improve constituent factors in ZT is reported, giving exceptionally high ZTave and PFave in n‐type PbSe. The nonstoichiometric, alloyed composition and resulting defect structures in new Pb1+xSe0.8Te0.2 (x = 0–0.125) system is key to this achievement. First, incorporating excess Pb unusually increases carrier mobility (µH) and concentration (nH) simultaneously in contrast to the general physics rule, thereby raising electrical conductivity (σ). Second, modifying charge scattering mechanism by the authors’ synthesis process boosts a magnitude of Seebeck coefficient (S) above theoretical expectations. Detouring the innate inverse proportionality between nH and µH; and σ and S enables independent control over them and change the typical trend of PF to temperature, giving remarkably high PFave ≈20 µW cm−1 K−2 from 300 to 823 K. The dual incorporation of Te and excess Pb generates unusual antisite Pb at the anionic site and displaced Pb from the ideal position, consequently suppressing lattice thermal conductivity. The best composition exhibits a ZTave of ≈1.2 from 400 to 823 K, one of the highest reported for all n‐type PbQ (Q = chalcogens) materials.
21 September 2023 in Journal of the American Ceramic Society
6 June 2023 in Advanced Science
All‐inorganic metal halide perovskite CsPbBr3 crystal is regarded as an attractive alternative to high purity Ge and CdZnTe for room temperature γ‐ray detection. However, high γ‐ray resolution is only observable in small CsPbBr3 crystal; more practical and deployable large crystal exhibits very low, and even no detection efficiency, thereby thwarting prospects for cost‐effective room temperature γ‐ray detection. The poor performance of large crystal is attributed to the unexpected secondary phase inclusion during crystal growth, which traps the generated carriers. Here, the solid–liquid interface during crystal growth is engineered by optimizing the temperature gradient and growth velocity. This minimizes the unfavorable formation of the secondary phase, leading to industrial‐grade crystals with a diameter of 30 mm. This excellent‐quality crystal exhibits remarkably high carrier mobility of 35.4 cm2 V−1 s−1 and resolves the peak of 137Cs@ 662 keV γ‐ray at an energy resolution of 9.91%. These values are the highest among previously reported large crystals.
1 November 2022 in Nano Energy
22 November 2023 in Advanced Energy and Sustainability Research
Flexible inorganic thermoelectric (TE) materials are beneficial to the development of wireless wearable devices due to their plasticity and high performance. Recently, many novel inorganic semiconductors with plasticity, such as ZnS single crystal, Ag2S‐based alloys, as well as single‐crystalline InSe and SnSe2, attract great attention. They are supposed to break the predicament between power output and mechanical deformability for TE systems with plasticity. To better understand the deformation of TE materials with plasticity and explore new systems, different deformation mechanisms for these plastically deformable inorganic TE materials are summarized. First, the concepts and requirements for inorganic TEs are presented with plasticity in wearable devices. Afterward, their mechanical properties and deformation mechanisms are elaborated including dislocation glide, interlayer slippage of atomic stacks, dual slippage of atomic stacks and dislocations, as well as phase transformation. Finally, a general outlook from previous research is suggested for forecasting the future directions. It is anticipated that this review can guide the design of inorganic TE materials with plasticity and provide insight into the wider application of plastically deformable inorganic semiconductors in electronic materials and devices.