4 March 2020 in Journal of Materials Chemistry C
Low-power near-infrared (NIR)-to-visible (vis) photon upconversion (UC) systems are in demand for biomedical, photovoltaic and photocatalytic applications; however, the practical utilization is still hampered by low UC efficiency. Aiming to identify efficiency-limiting factors, particularly in metallophthalocyanine-sensitized rubrene systems operational in the NIR-vis range, we thoroughly assessed subsequent energy transfer steps in the TTA-mediated UC scheme. A key limiting factor in the optimized UC systems was found to be rubrene's low statistical probability (f = 15.5 ± 3%) to obtain a singlet from two triplets via TTA. The f estimated under the dominance of TTA attained by continuous-wave excitation, i.e. the regime frequently encountered (or desired) in practical applications, was determined to be 4 times lower as compared to that obtained under femtosecond pulsed-laser excitation conditions. The results also demonstrate that the benefit of achieving larger emitter concentrations by introducing solubility increasing alkyl groups into the emitter in anticipation of enhanced triplet energy transfer cannot outcompete the severely reduced statistical probability factor (f = 5.3 ± 1%) of t-butyl-substituted rubrene. The maximum UC quantum yield (ΦUC = 5.6 ± 1.2%) estimated and verified by two independent methods in the optimized Pd-phthalocyanine–rubrene system is among the largest reported for NIR-to-vis UC systems absorbing at >730 nm. ΦUC is defined here as the number of UC photons emitted per number of absorbed ones, implying a theoretical limit of 50% for TTA-mediated UC.
5 March 2020 in Physical Chemistry Chemical Physics
Solid state NIR-to-visible photon upconversion (UC) mediated by triplet–triplet annihilation (TTA) is necessitated by numerous practical applications. Yet, efficient TTA-UC remains a highly challenging task. In this work palladium phthalocyanine-sensitized NIR-to-vis solid UC films based on a popular rubrene emitter are thoroughly studied with the primary focus on revealing the impact of t-butyl substitution in rubrene on the TTA-UC performance. The solution-processed UC films were additionally doped with a small amount of emissive singlet sink tetraphenyldibenzoperiflanthene (DBP) for collecting upconverted singlets from rubrene and in this way diminishing detrimental singlet fission. Irrespective of the excitation conditions used, t-butyl-substituted rubrene (TBR) was found to exhibit enhanced TTA-UC performance as compared to that of rubrene at an optimal emitter doping of 80 wt% in polystyrene films. Explicitly, in the TTA dominated regime attained at high excitation densities, 4-fold higher UC quantum yield (ΦUC) achieved in TBR-based films was caused by the reduced fluorescence concentration quenching mainly due to suppressed singlet fission. Under low light conditions, i.e. in the regime governed by spontaneous triplet decay, even though triplet exciton diffusion was obstructed in TBR films by t-butyl moieties, the subsequently reduced TTA rate was counterbalanced by both suppressed singlet fission and non-radiative triplet quenching, still ensuring higher ΦUC of these films as compared to those of unsubstituted rubrene films.
29 August 2019 in Journal of Materials Chemistry C
Efficient TADF relies on effective reverse intersystem crossing (rISC) from triplet to singlet manifold, and therefore the transition rate associated with this process must outcompete non-radiative decay rate of the triplets. Herein the issue of non-radiative triplet quenching in benzophenone-derived compounds frequently employed as blue TADF emitters in OLEDs is addressed and an effective way to suppress this quenching is proposed. TADF emitters designed for this study were based on phenone-derived electron-accepting units linked with multiple carbazolyl donors to deliver similar and large rISC rates (krISC ∼ 4 × 106 s−1), yet significantly different non-radiative triplet quenching rates (kT nr). We found that substitution of a loose phenyl moiety by a methoxy group in benzophenone suppresses kT nr by one order of magnitude (from 3 × 106 s−1 down to 0.3 × 106 s−1), while leaving rISC rate krISC almost unaffected. A 10 times enlarged ratio krISC/kT nr in 5tCzMeB as compared to that in 5tCzBP emitter suffices to retrieve the vast majority of triplet population via the rISC resulting in PL quantum yields of 0.99 and 0.58 in doped DPEPO and neat films, respectively. Sky-blue TADF OLEDs with doped and non-doped emissive layers based on 5tCzMeB demonstrated impressive maximum external quantum efficiency (EQE) values of 24.6% and 13.4%, respectively, whereas at 100 cd m−2 the devices exhibited 16.5% and 7.7% EQEs, respectively.
27 November 2019 in Physical Chemistry Chemical Physics
Thermally activated delayed fluorescence (TADF) compounds with a flexible donor–acceptor structure suffer from conformational disorder in solid-state, which deteriorates their emission properties as well as OLED performance. Accordingly, TADF materials with predictable solid-state emission properties are highly desirable. In this work, we analyse the relation between the molecular rigidity and solid-state TADF properties. Two TADF compounds, 4,6-bis(2-methyl-4-(10H-phenothiazin-10-yl)phenyl)pyrimidine (PTZ-mPYR) and 1,2,3,4-tetrakis(carbazol-9-yl)-5,6-dicyanobenzene (4CzPN), with similar emission properties in toluene solutions but different rigidity of the molecular structure were systematically studied. The analysis was supplemented by comparison of solid-state TADF properties of PTZ-mPYR with its analogue 4,6-bis(4-(10H-phenoxazin-10-yl)phenyl)pyrimidine (PXZ-PYR), bearing a more sterically constrained planar electron-donor unit. All compounds showed conformational disorder in diluted polymer films; however its extent directly depended on the molecular structure. Large dispersion of singlet–triplet energy gaps resulted in remarkably prolonged TADF lifetime for PTZ-mPYR with a less sterically constrained donor unit. In contrast, weakened conformational disorder in rigid 4CzPN with sterically crowded donor units was shown to ensure rapid TADF decay with only a threefold lower solid-state rISC rate as compared to toluene. Similarly, selection of a more sterically constrained planar electron-donor unit was also shown to be preferable for lowering the conformational disorder. Our findings are important for the future design of compounds with efficient solid-state TADF as well as for the further application in OLEDs with low external quantum efficiency roll-off.
11 May 2020 in Journal of Materials Chemistry C
Narrow-band deep-blue (emission peak < 460 nm) TADF emitters are in demand for commercial OLED display applications, yet the development of efficient emitters with low efficiency roll-off is very challenging. To address this issue, herein, we studied carbazole–naphthyridine (donor–acceptor)-based blue-emitting TADF compounds, which were designed by using both the H-bonding and sterically controlled charge-transfer (CT) interactions between D and A units. Methyl substitution employed at the first position of t-butyl-carbazole donors was found to affect CT strength and consequently the TADF properties of the studied compounds, enabling a significant reduction of delayed fluorescence lifetime (down to 3.1 μs) and enhancement of reverse intersystem crossing rate (up to 106 s−1). The naphthyridines were demonstrated to hold great potential as deep-blue TADF emitters suitable for both vacuum- and solution-processed TADF OLEDs. The optimized devices with 7 wt% naphthyridine emitter in a weakly polar mCP host delivered external quantum efficiencies (EQEs) of up to ∼17.6% and ∼13.5% for vacuum- and solution-processed OLEDs, respectively. Unsubstituted naphthyridine exhibited deep-blue (λmax < 460 nm) and narrow-band (FWHM = 66 nm) electroluminescence, whereas the more twisted methyl-substituted compound expressed broader band (FWHM > 80 nm) sky-blue (λmax ≈ 480 nm) emission. The demonstrated emitters are among the best-performing conventional D–A-type blue/deep-blue TADF emitters in terms of EQE and efficiency roll-off properties of their devices.
13 July 2018 in Chemical Science
To increase the practical usefulness of solid-state sensitized upconversion (UC) materials as components of solar energy harvesting systems, it is important to identify and suppress loss mechanisms, and increase the UC quantum yield (ΦUC). Here we focus on a benchmark UC system consisting of the emitter 9,10-diphenylanthracene (DPA) and the sensitizer platinum octaethylporphyrin (PtOEP) in a rigid poly(methyl methacrylate) (PMMA) matrix, and show that one of the major losses originates from Förster resonant energy transfer (FRET) from DPA back to PtOEP. Even though DPA emission lies within the PtOEP transparency window, the quantitative assessment of singlet exciton diffusion for samples with a high DPA content evidences that long-range FRET results in effective exciton trapping by PtOEP. A dramatic factor-of-6 reduction of the DPA emission quantum yield occurs even at PtOEP concentrations as low as 0.05 wt%. To alleviate this problem, we demonstrate a new concept based on the introduction of highly emissive sink sites to trap the singlet excitons produced upon annihilation prior to their quenching by the sensitizer. For DPA/PtOEP blends in PMMA, 1,6-bis-[2,5-di(dodecyloxyphenyl)ethynyl]pyrene is shown to be a useful sink, which results in 1.5-fold increase of the ΦUC. A maximum ΦUC of 2.7% was achieved, which is among the highest reported values for rigid sensitized UC polymers.