We report a new atomic layer deposition (ALD) process for yttrium oxide (Y2O3) thin films using tris(N,N′-diisopropyl-2-dimethylamido-guanidinato) yttrium(III) [Y(DPDMG)3] which possesses an optimal reactivity towards water that enabled the growth of high quality thin films. Saturative behavior of the precursor and a constant growth rate of 1.1 Å per cycle confirm the characteristic self-limiting ALD growth in a temperature range from 175 °C to 250 °C. The polycrystalline films in the cubic phase are uniform and smooth with a root mean squared (RMS) roughness of 0.55 nm, while the O/Y ratio of 2.0 reveal oxygen rich layers with low carbon contaminations of around 2 at%. Optical properties determined via UV/Vis measurements revealed the direct optical band gap of 5.56 eV. The valuable intrinsic properties such as a high dielectric constant make Y2O3 a promising candidate in microelectronic applications. Thus the electrical characteristics of the ALD grown layers embedded in a metal insulator semiconductor (MIS) capacitor structure were determined which resulted in a dielectric permittivity of 11, low leakage current density (≈10−7 A cm−2 at 2 MV cm−1) and high electrical breakdown fields (4.0–7.5 MV cm−1). These promising results demonstrate the potential of the new and simple Y2O3 ALD process for gate oxide applications.
19 February 2018 in ACS Applied Materials & Interfaces
In this paper, a direct chemical vapor deposition (CVD) approach is applied for the first time to synthesize high quality copper oxide (CuO), copper tungstate (CuWO 4 ) and tungsten oxide (WO 3 ) on F:SnO 2 (FTO) substrates for photocatalytic water splitting.
The intrinsic properties of semiconducting oxides having nanostructured morphology are highly appealing for gas sensing. In this study, the fabrication of nanostructured WO3 thin films with promising surface characteristics for hydrogen (H2) gas sensing applications is accomplished. This is enabled by developing a chemical vapor deposition (CVD) process employing a new and volatile tungsten precursor bis(diisopropylamido)‐bis(tert‐butylimido)‐tungsten(VI), [W(NtBu)2(NiPr2)2]. The as‐grown nanostructured WO3 layers are thoroughly analyzed. Particular attention is paid to stoichiometry, surface characteristics, and morphology, all of which strongly influence the gas‐sensing potential of WO3. Synchrotron‐based ultraviolet photoelectron spectroscopy (UPS), X‐ray photoelectron spectroscopy (XPS), X‐ray photoelectron emission microscopy (XPEEM), low‐energy electron microscopy (LEEM) and 4‐point van der Pauw (vdP) technique made it possible to analyze the surface chemistry and structural uniformity with a spatially resolved insight into the chemical, electronic and electrical properties. The WO3 layer is employed as a hydrogen (H2) sensor within interdigitated mini‐mobile sensor architecture capable of working using a standard computer's 5 V 1‐wirebus connection. The sensor shows remarkable sensitivity toward H2. The high, robust, and repeatable sensor response (S) is attributed to the homogenous distribution of the W5+ oxidation state and associated oxygen vacancies, as shown by synchrotron‐based UPS, XPS, and XPEEM analysis.