1 December 2003 in Materials Research
Flexible, free-standing piezo and pyroelectric composite with 0 to 3 connectivity was made up from Lead Zirconate Titanate (PZT) powder and poly(vinylidene fluoride-hexafluoropropylene) (PVDF-HFP) copolymer. The pyroelectric and the piezoelectric longitudinal (d33) coefficients were measured. A 50/50 vol.% PZT/PVDF-HFP composite resulted in piezo and pyroelectric coefficients of d33 = 25.0 pC/N and p = 4.5 × 10-4 C/m²K at 70 °C, respectively. Analysis of the complex permittivity in a wide range of frequency was carried out indicating lower permittivity of the composite in comparison with a permittivity of the PZT ceramic. The low value of the permittivity gives a high pyroelectric figure of merit indicating that this material can be used to build a temperature sensor in spite of the lower pyroelectric coefficient compared with PZT.
1 September 2002 in Sensors and Actuators A: Physical
1 December 2014 in Polymer Testing
LRLuciano Henrique Siliano Ricco
Luciano Henrique Siliano Ricco
1 July 2001 in Materials Research
A flexible piezoelectric composite with 0-3 connectivity, made from Lead Zirconate Titanate (PZT) powder and vegetable-based polyurethane (PU), was doped with small amount of semiconductor powder. As a result a composite with 0-0-3 connectivity was obtained. The nature of absorption and steady state electrical conduction and the dielectric behaviour have been studied for this ceramic/polymer composite. The dielectric loss processes of the composite were observed to be dominated by those the polymer. Adding a semiconductor phase in the composite the electrical conductivity can be controlled and a continuous electric flux path could be created between the PZT grains. This composite may be poled at low voltage and in shorter time compared with composites without a conductive phase
1 July 1998 in Journal of Materials Science
1 May 2002 in Materials Research Innovations
Flexible piezo- and pyroelectric composite was made in the thin film form by spin coating. Lead Zirconate Titanate (PZT) ceramic powder was dispersed in a castor oil-based polyurethane (PU) matrix, providing a composite with 0–3 connectivity. The dielectric data, measured over a wide range of frequency (10–5 Hz to 105 Hz), shows a loss peak around 100 Hz related with impurities in the polymer matrix. There is also an evidence of a peak in the range 10–4 Hz, possibly originating from the glass transition temperature Tg of the polymer. The pyroelectric coefficient at 343 K is 7.0×10–5 C·m–2·K–1 which is higher than that of β-PVDF (1×10–5 C·m–2·K–1).