Riaz Ahmad

Riaz Ahmad

Auto-generated profile, based on publicly available information

Riaz Ahmad

Department of Aerospace Engineering, School of Mechanical and Manufacturing Engineering (SMME), National University of Sciences and Technology (NUST), Islamabad, Pakistan

Research Focus & Metrics

Academic Career Length

2Years (2025-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
16 June 2025 in International Journal of Sustainable Energy
Verified
Journal Article
Open access
MKMuhammad Adnan Khan
Muhammad Adnan Khan
RARiaz Ahmad
Riaz Ahmad
SJSyed Husain Imran Jaffery
Syed Husain Imran Jaffery
SBShahid Ikramullah Butt
Shahid Ikramullah Butt
Muhammad Salman KhanMuhammad Salman Khan
Muhammad Salman Khan
DZDanyal Zahid
Danyal Zahid

15 May 2026 in Scientific Reports
Verified
Journal Article
Open access
PDF file
MKMuhammad Adnan Khan
Muhammad Adnan Khan
RARiaz Ahmad
Riaz Ahmad
MHMuhammad Rizwan ul Haq
Muhammad Rizwan ul Haq
SJSyed Husain Imran Jaffery
Syed Husain Imran Jaffery
DZDanyal Zahid
Danyal Zahid
Sustainable machining of Inconel 718, a nickel-based superalloy that is highly valuable in aerospace, is faced with the challenge that it has high energy requirements and poor machinability. In this study, a new energy consumption map and combined energy-morphology framework is proposed which draws a correlation between a specific cutting energy (SCE) and the mechanics of chip formation. Detailed experimental profiling maintained over a variety of cutting speeds (25–75 m/min ) and feed rates (0.05–0.20 mm/rev) demonstrates a SCE profile with a high-energy ridge of greater than 3.0 J/mm³ at lower feed rates, and a low-energy trough of less than 2.0 J/mm³ at higher speeds and feeds. Quantitative measurements of chip morphology suggest that low-SCE conditions are coupled with fine serrations, shear bands of less than 24 μm, compression ratios of less than 1.2, and relatively large included angles hence indicating efficient thermally assisted shear localization. The best processing window of 62.5–75 m/min and 0.10–0.15 mm/rev was found that allows to save energy and at the same time improve chip control. The derived energy-morphology map is a viable tool of shop-floor decision making, which helps to achieve energy-efficient machining.