25 April 2025 in Expert Systems with Applications
5 May 2023 in International Journal of Control, Automation, and Systems
4 February 2025 in IEEE Sensors Journal
Lead-through programming (LTP) enables the operators to guide the manipulator directly to the desired target position, significantly improving adaptability and flexibility. However, direct drive manipulators encounter significant challenges in force sensorless LTP due to the high inertia, external force sensitivity, and complications from kinematics singularities. To enhance the interaction compliance and safety, a novel force sensorless LTP control strategy is proposed for direct drive manipulators. Specifically, an enhanced generalized momentum observer (EGMO) based on a nominal model is designed to mitigate phase lag caused by filtering measurement noise through a phase compensation mechanism. Additionally, the introduction of dither signal and radial basis function neural network (RBFNN) learning methods reduces dynamic uncertainties, improving control performance. Then, a kinematics singularity avoidance control method is proposed, which switches between impedance and admittance control by predicting singularity points in advance, enabling the manipulator to avoid kinematic singularity in the task space with minimal position and orientation deviations, promoting a more compliant and safe interaction between the manipulator and the human operator. Finally, the proposed methods are validated on a six-degree-of-freedom (DOF) direct drive manipulator under three typical singular scenarios. The results demonstrate the effectiveness and practicality of the proposed method.
27 January 2025 in Applied Soft Computing
7 January 2024 in International Journal of Adaptive Control and Signal Processing
27 November 2024 in Transactions of the Institute of Measurement and Control
Model-based feedforward control is a critical control method for high-dynamic and high-precision requirements of turntable servo systems. However, the turntable servo system will be affected by the change of working state in actual work, so the traditional physical feedforward control makes it difficult to obtain an accurate model of the turntable servo system. In this article, a feedforward controller based on a physics-guided neural network (PGNN) is proposed to improve the tracking performance of the turntable servo system. Firstly, a PGNN model is constructed according to the characteristics of the turntable, which is divided into a physical model part and a neural network part. Then the above model is applied to the design of the feedforward controller to replace the traditional feedforward controller. In order to improve the extension of the network, a new penalty function mechanism is proposed, which integrates regularization and physical consistency on the basis of the mean square error term. The automatic tuning algorithm of the parameters of the PGNN model is also designed to facilitate its wide application in the field of turntable control. Simulation results show that the neural network model designed in this article can accurately describe the nonlinear characteristics of the turntable servo system, and the fitting effect under different forms of excitation signals is better than the traditional physical model, with strong generalization ability and robustness. In addition, the feedforward control based on the model effectively improves the tracking accuracy of the system, which has important value and significance for the intelligent development of traditional servo control systems.