Marco Pizzorni

Marco Pizzorni

Auto-generated profile, based on publicly available information

Marco Pizzorni

Department of Mechanical, Energy, Management and Transport Engineering, Polytechnic School, University of Genoa, Genoa, Italy

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
6 April 2021 in The International Journal of Advanced Manufacturing Technology
Verified
Journal Article
Open access
PDF file
APAlberto Parmiggiani
Alberto Parmiggiani
MPMirko Prato
Mirko Prato
MPMarco Pizzorni
Marco Pizzorni
Recent years have seen the wide diffusion of composite materials in many manufacturing fields and the rapid evolution of additive manufacturing. Lately, these technologies have been combined practically allowing the fabrication of continuous-fiber reinforced polymer parts via 3D-printing. This topic is gaining attention both in the research community and among industrial users. Because of their novelty, such manufacturing methods are, however, still not thoroughly understood, and their performance limits have not yet been fully characterized. This study aims at analyzing the mechanical resistance of components made with continuous carbon fiber (CCF) thermoplastic materials by means of fused filament fabrication (FFF), focusing on the influence of the fiber orientation on such properties. In particular, both the tensile and the bending characteristics are evaluated according to the relative test standards, in specimens with both unidirectional and mixed-isotropic configurations. The experimental findings are compared with a set of reference specimens made with a base polymer filled with chopped “short” carbon fibers, allowing one to appreciate the advantages or limitations of the different fiber arrangements.

1 February 2022 in Composites Part B: Engineering
Verified
Journal Article
Closed access
MPMarco Pizzorni
Marco Pizzorni
Enrico LertoraEnrico Lertora
Enrico Lertora
APAlberto Parmiggiani
Alberto Parmiggiani

24 January 2019 in Polymers
Verified
Journal Article
Open access
PDF file
Chiara MandolfinoChiara Mandolfino
Chiara Mandolfino
Enrico LertoraEnrico Lertora
Enrico Lertora
CGCarla Gambaro
Carla Gambaro
MPMarco Pizzorni
Marco Pizzorni
Polyolefins are considered among the most difficult polymeric materials to treat because they have poor adhesive properties and high chemical barrier responses. In this paper, an in-depth study is reported for the low pressure plasma (LPP) treatment of neutral polypropylene to improve adhesion properties. Changes in wettability, chemical species, surface morphology and roughness of the polypropylene surfaces were evaluated by water contact angle measurement, X-ray photoelectron spectroscopy and, furthermore, atomic force microscopy (AFM). Finally, the bonded joints were subjected to tensile tests, in order to evaluate the practical effect of changes in adhesion properties. The results indicate that plasma is an effective treatment for the surface preparation of polypropylene for the creation of bonded joints: contact angles decreased significantly depending on the plasma-parameter setup, surface morphology was also found to vary with plasma power, exposure time and working gas.

9 February 2019 in The International Journal of Advanced Manufacturing Technology
Verified
Journal Article
Closed access
PDF file
MPM. Pizzorni
M. Pizzorni
ELE. Lertora
E. Lertora
CGC. Gambaro
C. Gambaro
Chiara MandolfinoChiara Mandolfino
Chiara Mandolfino
Marco SalernoMarco Salerno
Marco Salerno
MPMirko Prato
Mirko Prato


1 June 2020 in International Journal of Adhesion and Adhesives
Verified
Journal Article
Closed access
MPM. Pizzorni
M. Pizzorni
ELE. Lertora
E. Lertora
Chiara MandolfinoChiara Mandolfino
Chiara Mandolfino