Matthias Bräuninger

Matthias Bräuninger

Auto-generated profile, based on publicly available information

Matthias Bräuninger

Ecole Polytechnique Fédérale de Lausanne (EPFL), Institute of Microengineering (IMT), Photovoltaics and Thin-Film Electronics Laboratory, Rue de la Maladière 71b, 2002 Neuchâtel, Switzerland

Research Focus & Metrics

Academic Career Length

18Years (2009-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
11 June 2018 in Nature Materials
Verified
Journal Article
Closed access
PDF file
FSFlorent Sahli
Florent Sahli
JWJérémie Werner
Jérémie Werner
BKBrett A. Kamino
Brett A. Kamino
MBMatthias Bräuninger
Matthias Bräuninger
RMRaphaël Monnard
Raphaël Monnard
CBChristophe Ballif
Christophe Ballif

3 August 2016 in ACS Energy Letters
Verified
Journal Article
Open access
JWJérémie Werner
Jérémie Werner
LBLoris Barraud
Loris Barraud
AWArnaud Walter
Arnaud Walter
MBMatthias Bräuninger
Matthias Bräuninger
FSFlorent Sahli
Florent Sahli
CBChristophe Ballif
Christophe Ballif
Combining market-proven silicon solar cell technology with an efficient wide band gap top cell into a tandem device is an attractive approach to reduce the cost of photovoltaic systems. For this, perovskite solar cells are promising high-efficiency top cell candidates, but their typical device size (<0.2 cm2), is still far from standard industrial sizes. We present a 1 cm2 near-infrared transparent perovskite solar cell with 14.5% steady-state efficiency, as compared to 16.4% on 0.25 cm2. By mechanically stacking these cells with silicon heterojunction cells, we experimentally demonstrate a 4-terminal tandem measurement with a steady-state efficiency of 25.2%, with a 0.25 cm2 top cell. The developed top cell processing methods enable the fabrication of a 20.5% efficient and 1.43 cm2 large monolithic perovskite/silicon heterojunction tandem solar cell, featuring a rear-side textured bottom cell to increase its near-infrared spectral response. Finally, we compare both tandem configurations to identify efficiency-limiting factors and discuss the potential for further performance improvement.

9 October 2017 in Advanced Energy Materials
Verified
Journal Article
Closed access
PDF file
FSFlorent Sahli
Florent Sahli
BKBrett A. Kamino
Brett A. Kamino
JWJérémie Werner
Jérémie Werner
MBMatthias Bräuninger
Matthias Bräuninger
BPBertrand Paviet‐Salomon
Bertrand Paviet‐Salomon
CBChristophe Ballif
Christophe Ballif

26 February 2018 in ACS Energy Letters
Verified
Journal Article
Closed access
JWJérémie Werner
Jérémie Werner
GNGizem Nogay
Gizem Nogay
FSFlorent Sahli
Florent Sahli
TYTerry Chien-Jen Yang
Terry Chien-Jen Yang
MBMatthias Bräuninger
Matthias Bräuninger
CBChristophe Ballif
Christophe Ballif

2 November 2009 in Physical Review Letters
Verified
Journal Article
Closed access
PDF file
MMMarkus Müller
Markus Müller
MBMatthias Bräuninger
Matthias Bräuninger
BTBjörn Trauzettel
Björn Trauzettel
We investigate the temperature dependence of conductivity in ballistic graphene using Landauer transport theory. We obtain results which are qualitatively in agreement with many features recently observed in transport measurements on high mobility suspended graphene. The conductivity σ at high temperature T and low density n grows linearly with T, while at high n we find σ∼|n| with negative corrections at small T due to the T dependence of the chemical potential. At moderate densities the conductivity is a nonmonotonic function of T and n, exhibiting a minimum at T=0.693ℏv|n| where v is the Fermi velocity. We discuss two kinds of Fabry-Perot oscillations in short nanoribbons and their stability at finite temperatures.

20 August 2014 in Journal of Applied Physics
Verified
Journal Article
Closed access
WFWangyang Fu
Wangyang Fu
PMPéter Makk
Péter Makk
RMRomain Maurand
Romain Maurand
MBMatthias Bräuninger
Matthias Bräuninger
CSChristian Schönenberger
Christian Schönenberger
We have fabricated graphene spin-valve devices utilizing scalable materials made from chemical vapor deposition (CVD). Both the spin-transporting graphene and the tunnel barrier material are CVD-grown. The tunnel barrier is realized by Hexagonal boron nitride, used either as a monolayer or bilayer and placed over the graphene. Spin transport experiments were performed using ferromagnetic contacts deposited onto the barrier. We find that spin injection is still greatly suppressed in devices with a monolayer tunneling barrier due to resistance mismatch. This is, however, not the case for devices with bilayer barriers. For those devices, a spin relaxation time of ∼260 ps intrinsic to the CVD graphene material is deduced. This time scale is comparable to those reported for exfoliated graphene, suggesting that this CVD approach is promising for spintronic applications which require scalable materials.