The development of inorganic nanophosphors is an active research field due to many applications, including optical gas sensing materials. We found a systematic dependence of the photoluminescence (PL) of europium (Eu 3+ ) impurity ions in zirconia (ZrO 2 ) nanocrystals on the ambient oxygen concentration in a O 2 /N 2 mixture at normal pressure. Europium-doped ZrO 2 powders were synthesized via a sol–gel route. Heat-treatment at 1200 °C resulted in a well-developed monoclinic phase (XRD crystallite size of ~50 nm) and an intense PL of Eu 3+ ions residing in the dominant phase (Eu 3+ was excited directly at 395 or 464 nm). Co-doping with niobium resulted in a narrowing of the PL emission lines. Only Nb 5+ was detected by XPS and is believed to charge-compensate Eu 3+ activators throughout the material leading to a more regular crystal lattice. At room temperature, the exposure to oxygen suppressed the Eu 3+ fluorescence, whereas, at elevated temperatures (300 °C), the effect was reversed. At 300 °C and under a focused continuous laser beam, a substantial PL response (>50%) was achieved when switching 100% of N 2 for 100% of O 2 . PL decay kinetics clearly showed that at 300 °C fluorescence quenching centers were induced within the material by oxygen desorption. The relatively fast (<5 min) and sub-linear PL response to the changes of oxygen concentration shows that ZrO 2 :Eu,Nb is a promising PL-based oxygen sensing material over a wide-range of oxygen pressures.
1 January 2020 in Sensors and Actuators B: Chemical
Increase–decrease in oxygen gas concentration results in increase–decrease in fluorescence of TiO2:Sm3+ films; this effect is especially pronounced around the Au/SiO2 nanoparticles with which the samples are decorated.
Present work investigates the applicability of nanosized TiO2 (anatase) as a potential optical sensor material for ambient oxygen below room temperature. Titania nanopowders with grain sizes of 10 and 40 nm are prepared via the sol-gel route and tested for the gas response in water deficit conditions. Both powders exhibit sensitivity against oxygen. At-50 °C 40 nm grain size powder remains sensitive to the ambient changes and the PL output increases ~50% whereas 10 nm grain size powders photoluminescence is quenched.