Julian Lebrato

Julian Lebrato

Auto-generated profile, based on publicly available information

Julian Lebrato

Grupo Tratamiento de Aguas Residuales, Escuela Universitaria Politécnica, Universidad de Sevilla, Virgen de Africa 7, 41011 Sevilla, Spain

Research Focus & Metrics

Academic Career Length

37Years (1990-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 July 2006 in Bioresource Technology
Verified
Journal Article
Closed access
CACarmen Arnaiz
Carmen Arnaiz
JGJ.C. Gutierrez
J.C. Gutierrez
JLJ. Lebrato
J. Lebrato

1 September 2018 in Surface and Coatings Technology
Verified
Journal Article
Closed access
CDC. Domínguez-Trujillo
C. Domínguez-Trujillo
Fátima Ternero FernándezFátima Ternero Fernández
Fátima Ternero Fernández
JRJosé Antonio Rodríguez-Ortiz
José Antonio Rodríguez-Ortiz
SHS. Heise
S. Heise
ABA.R. Boccaccini
A.R. Boccaccini
Yadir Torres HernándezYadir Torres Hernández
Yadir Torres Hernández

1 February 1994 in Water Research
Verified
Journal Article
Closed access
CMC. Maqueda
C. Maqueda
JRJ.L. Pérez Rodríguez
J.L. Pérez Rodríguez
JLJ. Lebrato
J. Lebrato

1 November 2003 in Environmental Technology
Verified
Journal Article
Closed access
CACarmen Arnaiz
Carmen Arnaiz
Pierre BuffièrePierre Buffière
Pierre Buffière
SES. Elmaleh
S. Elmaleh
JLJ. Lebrato
J. Lebrato
RMR. Moletta
R. Moletta
This paper describes the application of the inverse fluidization technology to the anaerobic digestion of dairy wastewater. Two reactors were investigated: the inverse fluidized bed reactor and the inverse turbulent reactor. In these reactors, a granular floating solid is expanded by a down‐flow current of effluent or an up‐flow current of gas, respectively. The carrier particles (Extendospheres(™)) were chosen for their large specific surface area (20,000 m2m−3) and their low energy requirements for fluidization (gas velocity of 1.5 mm s−1, 5.4 m h−1). Organic load was increased stepwise by reducing hydraulic retention time from more than 60 days to 3 days, while maintaining constant the feed COD concentration. Both reactors achieved more than 90% of COD removal, at an organic loading rate of 10–12 kgCOD m−3d−1, respectively. The performances observed were similar or even higher than that of other previously tested fluidized bed technologies treating the same wastewater. It was found that the main advantages of this system are: low energy requirement, because of the low fluidization velocities required; there is no need of a settling device, because solids accumulate at the bottom of the reactor, so they can be easily drawn out and particles with high‐biomass content can be easily recovered. Lipid phosphate concentration has been revealed as a good method for biomass estimation in biofilms since it only includes living biomass.

1 January 2019 in Surface and Coatings Technology
Verified
Journal Article
Closed access
CDCristina Domínguez-Trujillo
Cristina Domínguez-Trujillo
Ana M. BeltranAna M. Beltran
Ana M. Beltran
MGMaria D. Garvi
Maria D. Garvi
ASAlba Salazar-Moya
Alba Salazar-Moya
JLJulián Lebrato
Julián Lebrato
Yadir Torres HernándezYadir Torres Hernández
Yadir Torres Hernández

1 January 2006 in Biochemical Engineering Journal
Verified
Journal Article
Open access
CACarmen Arnaiz
Carmen Arnaiz
JGJ.C. Gutierrez
J.C. Gutierrez
JLJ. Lebrato
J. Lebrato
Many different types of support materials are used in anaerobic fluidized bed in order to obtain high levels of biomass in the reactors. A material is usually considered the most suitable in terms of physical-chemical parameters or reactor performance, but not in terms of microbial adhesion. In this work, two commercial materials were tested as support for anaerobic biomass : peflite a.nd sepiolite. Biofilm accumulation was estimated by two methods, attached volatile solids and lipid phosphate concentration, both determined directly on attached biofilm. The biomass adhesion on sepiolite was higher than the perlite for ali the tested initial total organic carbon concentration in the reactors. We have found that biomass measurement method developed directly on attached biofilm is relevan! to the amount of living cells. We also discuss the suitability of estimating attached