Wei-Sheng Yu

Wei-Sheng Yu

Auto-generated profile, based on publicly available information

Wei-Sheng Yu

Professor, Dept. of Bioenvironmental Systems Engineering, National Taiwan Univ., Taipei, Taiwan 106, ROC

Research Focus & Metrics

Academic Career Length

23Years (2004-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 December 2004 in Journal of Hydraulic Engineering
Verified
Journal Article
Closed access
WYWei-Sheng Yu
Wei-Sheng Yu
Shaohua Marko HSUShaohua Marko HSU
Shaohua Marko HSU
KFKan-Long Fan
Kan-Long Fan
For investigating selective withdrawal problems, laboratory experiments were conducted in a horizontal flume with a co-directional two-layer flow of different density into a line sink. Saline water was used as the fluid of the lower layer instead of sediment-laden turbid water for achieving a steady state. In this study, a trend curve was produced using the data of many runs which were taken under varying conditions from aspiration of both layers to only lower-layer aspiration. An adequate parameter for determining the critical condition was obtained from this trend curve. The critical condition is defined as the beginning or ending of aspiration for the upper layer. Suitable variables for the parameter are also discussed. A theoretical formula is suggested and verified, which is better than a traditional empirical formula for calculating the withdrawal concentration. Effects of slot elevation on the lower layer flow and the thickness of the mixing layer are also discussed.

1 October 2005 in Journal of Irrigation and Drainage Engineering
Verified
Journal Article
Closed access
CLChen-Wuing Liu
Chen-Wuing Liu
WYWei-Sheng Yu
Wei-Sheng Yu
WCWen-Teng Chen
Wen-Teng Chen
SCShih-Kai Chen
Shih-Kai Chen
The study aimed to determine the number of cultivation cycles required to reform the plough sole once it has been destroyed or removed from the paddy. An ad hoc infiltration column experiment, which is a cylinder of 50cm in diameter and 140cm long, was setup to simulate the processes of ploughing and compaction, the two major forces exerted by a tractor, for developing a plough sole in rice paddy. Three experimental conditions were investigated, namely developing the plough sole by ploughing, compaction, and a combination of ploughing and compaction. The results of the change in the infiltration rate, soil dry bulk density, and weight percentage of clay in an experimental soil column were measured and evaluated. The experimental results show that, the infiltration rate decreases to 63, 29, and 2% of its initial value with ploughing eight times, compaction 30 times, and combination of ploughing and compaction 14 times, respectively. Moreover, the soil bulk density increases from 1.51 to 1.53, 1.61, and 1.71gcm−3 , respectively. Finally, the weight percentage of clay in the plough sole as a result of clay particles moving down from above and increases from 6.2 to 8.2, 6.2, and 14.8%, respectively, over the experimental period. The ploughing rearranged clay content distribution and the compaction increased soil bulk density. Applying these two practices in sequence effectively increased the soil bulk density and reduced the infiltration rate. The results also indicate that after 14 ploughing and compaction the infiltration rate did not further decrease, suggesting that the soil structure could no longer be changed and the plough sole had successfully been reformed. The quantitative result of this work provides valuable information on how to rehabilitate a plough sole once it has been destroyed and needs to be reformed from the paddy field.