An experimental, laboratory-scale optical fiber drawing tower based on CO laser heating has been developed and used to fabricate speciality optical fiber. The CO laser was utilized in a symmetric four beam heating system. The localized and responsive heating time of the laser-based furnace was beneficial for manufacturing crystalline core fibers, specifically, silicon core optical fibers. Moreover, the specific absorption properties of the CO laser radiation in silica have been evaluated with the aid of finite element modeling. In comparison to the more traditional laser, CO lasers were found to improve temperature uniformity and heating times while minimizing surface evaporation.
We demonstrate a method for rapid prototyping of optical fibers. Silica-based glass rods were 3D printed using laser powder deposition. Different doping of the 3D printed rods is evaluated, including alumina, titania, and erbium-doped glass. The rods were subsequently used as the core material in preforms with optical fibers drawn using a laser-based draw tower. A transmission loss of 3.2 dB/m was found for a fiber with 1 wt% titania doped core and pure silica cladding. Using this fabrication method, prototyping from powder to optical fiber could be achieved within a few hours.
18 November 2021 in Journal of the Optical Society of America B
Here, we present an innovative preform manufacturing technique for specialty optical fibers based on a carbon monoxide laser heating a rotating preform. The setup performance is evaluated with the aid of finite element modeling. The fabrication process is described in detail using silicon core preforms as a benchmark. The hybrid material nature of such a preform is addressed, together with the relevant characteristics, such as the difference in thermal conductivity and thermal expansion. Silicon core preforms with a wide range of core sizes were manufactured, proving the viability of this system for the development of specialty optical fibers based on novel materials.
A quadrature phase-shift detection system for interferometry has been conceptualized and evaluated. The main components, a microcontroller and two photodetectors, make a versatile low-cost detection system for displacement measurements or more generally phase-change measurements. The system is capable of sampling at 5 kHz with a spatial resolution of 1 nm.
Silicon core fibers are a promising candidate for optoelectronic and photonic applications. Fabrication and post-processing of those fibers is thus far done without precise knowledge of the processing temperatures. Here, a simple technique is presented that allows for in-situ temperature monitoring during thermal processing of silicon core fibers. The temperature was probed across the silicon melting point and cooling rates above 3500 °C s−1 were measured. The silicon core was found to be molten at a temperature of 1281 °C, more than 100 °C below the bulk silicon melting point. This is attributed to stress inbuilt to silicon core fibers during the fabrication process.
The optical fiber itself can function as a partially reflecting concentric cavity interferometer when transversely probed by a focused laser beam. In this study, the thermal response of the fiber heated by a CO2-laser beam was characterized by monitoring the back-scattered interference pattern. Simultaneous measurement of the Bragg wavelength shift of an inscribed, high-temperature stable fiber Bragg grating allowed for calibration of the temperature-dependent phase response of the interferometer. The presented technique allows for in-situ non-contact temperature measurements up to the glass softening point.