The evaporation dynamics of multiple droplet arrays is important in inkjet printing and spray coating, where co-operative “shielding” effects increase the overall evaporation time. However, current measurement methods provide limited information on how individual droplets contribute to the overall dynamics. In this work, we present a simple interferometric technique for precise measurements of droplet evaporation rates, which is not possible via traditional approaches. We validate the technique on a single droplet. We then extend our analysis to ordered and random 2D arrays of droplets. We demonstrate that the evaporation rate is highly dependent on the position of the droplet within the array and its confinement. The more confined droplets exhibit lower evaporation rates. Our results of ten different configurations and well over 100 droplets are in good quantitative agreement with a recent analytical model of co-operative evaporation rates. Our approach opens up possibilities for studies of collective evaporation effects, including in areas of current importance such as sneezes and exhaled breath.
The spontaneous dewetting of a liquid film from a solid surface occurs in many important processes, such as printing and microscale patterning. Experience suggests that dewetting occurs faster on surfaces of higher film repellency. Here, we show how, unexpectedly, a surrounding viscous phase can switch the overall dewetting speed so that films retract slower with increasing surface repellency. We present experiments and a hydrodynamic theory covering five decades of the viscosity ratio between the film and the surrounding phase. The timescale of dewetting is controlled by the geometry of the liquid-liquid interface close to the contact line and the viscosity ratio. At small viscosity ratio, dewetting is slower on low film-repellency surfaces due to a high dissipation at the edge of the receding film. This situation is reversed at high viscosity ratios, leading to a slower dewetting on high film-repellency surfaces due to the increased dissipation of the advancing surrounding phase.
The stability of liquid films on surfaces is critically important in microscale patterning and the semiconductor industry. If the film is sufficiently thin, it may spontaneously dewet from the surface. The timescale and rate of dewetting depend on the film repellency of the surface and the properties of the liquid. Therefore, control over the repellency requires modifying surface chemistry and liquid properties to obtain the desired rate of film retraction. Here, we report how the dynamics of a receding thin liquid stripe to a spherical cap droplet can be controlled by programming surface repellency through a non-contact electrostatic method. We observe excellent agreement between the expected scaling of the dynamics for a wide range of voltage-selected final contact angles. Our results provide a method of controlling the dynamics of dewetting with high precision and locality relevant to printing and directed templating.
22 April 2022 in Journal of Physics D: Applied Physics
We show that surface-localized dielectrophoresis-driven wetting of anisotropic nematic liquid crystal sessile droplets obeys the same relationship, , which has previously been found for isotropic liquid droplets, even though the nematic liquid crystal phase possesses a uniaxial dielectric permittivity tensor. We also demonstrate that the dielectrowetting coefficient , which determines the magnitude of the reduction in the contact angle, from to , through the action of a potential difference , can be controlled by the frequency of the applied voltage between interdigitated electrodes beneath a droplet of highly dispersive nematic liquid crystal. Our Q-tensor modelling of the electric field-induced 2-dimensional n-director distortions within a nematic droplet elucidates how this linear relationship holds for voltages when exceeds 3°–4°.