In this paper, we report the 3-D electrical conductivity distribution beneath the Australian continent in the depth range 410–1600 km, which we have imaged by inverting C-response estimates from a regional network of geomagnetic observatories. The inversion scheme is based on a quasi-Newton optimization method while the forward algorithm relies on an integral-equation approach. To properly account for the ocean effect in responses at coastal observatories we included a high-resolution (1° × 1°) fixed thin laterally varying surface conductance layer. As starting model in the inversion we considered a laboratory-based 3-D conductivity model of the region obtained from seismic surface wave data and thermodynamic modelling. This model provides a good fit to observed C-response estimates supporting its choice as initial model. The most striking feature of the obtained 3-D model is a high-conductivity anomaly in the lower part of the mantle transition zone (MTZ; 520–660 km depth) beneath southeastern Australia implying considerable lateral as radial heterogeneity in the conductivity structure. The high-conductivity region appears to be 0.5–1 log units more conductive than previous global and other regionalized 1-D models. Further analysis using laboratory-based conductivity models combined with thermochemical phase equilibrium computations shows that the strong conductivity anomaly implies water contents of around 0.1 wt per cent in the upper part and >0.4 wt per cent in the lower part of the MTZ. This implies a large MTZ water reservoir that likely totals one to three times that which currently resides in the oceans. The amount of water in the lower MTZ appears to exceed the experimentally determined water storage capacity of the main lower MTZ mineral ringwoodite, which, as a result, undergoes dehydration-induced partial melting. Including contributions to conductivity from a thin melt layer (20 km thick) located in the mid-MTZ increases conductivity locally in the melt layer to ∼1 S m−1, that is, about 0.5 log units more conductive than the average surrounding mantle. This provides an adequate explanation for the strong conductivity anomalies observed beneath part of the continent and points to lateral variations in melt in the MTZ.
Since phreatic eruptions often occur near the surface, it is important to understand the shallow subsurface structure of a volcano to clarify the eruption mechanism. The 2015 phreatic eruption at Owakudani, Hakone Volcano, Japan, was preceded by localized uplift and intensified steam activity. However, the cause of these events is unknown due to a poor understanding of the shallow subsurface structure. We report on a three‐dimensional resistivity structure inferred from dense audio‐frequency magnetotelluric surveys conducted in Owakudani that revealed a ∼100‐m thick conductive layer at the surface underlain by a resistive section, at the edge of which eruptions craters were located. This conductive layer is estimated to be a low‐permeability cap layer, because the inflation source prior to the eruption is located beneath it and the ejecta from the eruption was reported to have originated from a depth of 100 m or less.
17 May 2024 in Journal of Geophysical Research: Solid Earth
Intraplate earthquakes occur more frequently in the Japanese islands than in other regions. Large intraplate earthquakes in the island arc preferentially occur in strain concentration zones detected by geological and geodetic studies. Crustal heterogeneity plays a crucial role in generating large intraplate earthquakes and strain concentrations. Thus, we elucidated the crustal heterogeneities beneath a strain concentration area on the back‐arc side of the northeastern Japan Arc based on electrical resistivity, which is sensitive to weak zones in the crust. By deploying wideband magnetotelluric surveys, we revealed the three‐dimensional electrical resistivity structure in the crust, suggesting the coexistence of two different types of strain‐concentration mechanisms in the strain‐concentration area. The shallow conductive layers and lower‐crustal conductors appear to act as low‐elastic‐modulus and low‐viscosity areas, respectively, and are responsible for the strain concentration. We found shallow and lower‐crustal conductors in the strain concentration zone revealed by geological studies. Those conductive areas are considered to act as mechanically weak zones and cause stress loading on the brittle pars of pre‐existing faults, resulting in large intraplate earthquakes. The resultant earthquakes presumably contribute to strain accumulation on a geological timescale. In addition, a spatial correlation between the epicenters of large intraplate earthquakes and edges of lower‐crustal conductors implies the contribution of the fluids in the lower crust to the generation of large earthquakes. We also identified vertical conductors ranging from the lower crust to Quaternary volcanoes, which may indicate trans‐crustal magmatic systems under these volcanoes.