The vibration of wind turbine towers is relevant to the reliability of the wind turbine structure and the quality of power production. It produces both ultimate loads and fatigue loads threatening structural safety. This paper aims to reduce vibration in wind turbine towers using an active damper named the twin rotor damper (TRD). A single degree of freedom (SDOF) oscillator with the TRD is used to approximate the response of wind turbines under a unidirectional gusty wind with loss of the electrical network. The coincidence between the wind gust and the grid loss is studied to involve the maximum loading on the structure. The performance of the proposed damping system under the maximum loading is then evaluated on the state-of-the-art wind turbine NREL 5 MW. The effectiveness of the TRD is compared to a passive tuned mass damper (TMD) designed with similar requirements. The numerical results reveal that, at the 1st natural mode, the TRD outperforms the passive TMD by three to six times. Moreover, the results show that the TRD is effective in reducing ultimate loads on wind turbine towers.
22 April 2006 in Structural and Multidisciplinary Optimization
Piezoelectric actuators are electro-mechanical devices widely used in mechatronics, robotics, vibro-acoustics, optics, active structures. Spatial and car industries are long-date users. They may be used in complex measurement systems for producing precisely controlled micro-displacements or for dynamic excitation of the structure whose response is studied. The axial compression mode multilayer actuator has several piezoelectric plates, usually of thickness 0.1 - 0.2 mm, separated by metallic electrodes. They are placed between thicker, protecting blocks placed at each end and also in intermediate positions. The active elements are electrically connected in parallel, and mechanically in series. The assembly may be pre-stressed in a metallic housing or just resin-protected. Any mechanical stressing of the actuator with the exception of its compression may lead to its destruction. Available data about the static use of such assemblies describe their deformation as being an elongation along the axial direction, characterized by a simple translation of the end face. In fact, the hybrid, experimental-numerical study presented here shows that when applying a DC voltage, even with no mechanical load for the actuator, its strain state is complex and is accompanied by the apparition of internal stress concentrations. The actuator structural integrity may be affected and the force applied to the external mechanical load may deviate from the axial direction