1 June 2019 in Carbohydrate Polymers
Nanocellulose prepared from cellulose oxalate has been discussed as an alternative to other methods to prepare cellulose nanofibrils or crystals. The current work describes the use of a bulk reaction between pulp and oxalic acid dihydrate to prepare cellulose oxalate followed by homogenization to produce nanocellulose. The prepared nanocellulose is on average 350 nm long and 3-4 nm wide, with particles of size and shape similar to both cellulose nanofibrils and cellulose nanocrystals. Films prepared from this nanocellulose have a maximum tensile stress of 140-200 MPa, strain at break between 3% and 5%, and oxygen permeability in the range of 0.3-0.5 cm3 μm m-2 day-1 kPa-1 at 50% relative humidity. The presented results illustrate that cellulose oxalates may be a low-cost method to prepare nanocellulose with properties reminiscent of those of both cellulose nanofibrils and cellulose nanocrystals, which may open up new application areas for cellulose nanomaterials.
1 February 2019 in Nordic Pulp & Paper Research Journal
Sustainable thermal insulating materials produced from cellulosic fibers provide a viable alternative to plastic insulation foams. Industrially available, abundant, and inexpensive mechanical pulp fiber and recycled textile fiber provide potential raw materials to produce thermal insulating materials. To improve the fire retardancy of low-density thermal insulating materials produced from recycled cotton denim and mechanical pulp fibers, bio-based fire retardants, such as sulfonated kraft lignin, kraft lignin, and nanoclays, were coated onto sustainable insulating material surfaces to enhance their fire retardancy. Microfibrillated cellulose was used as a bio-based binder in the coating formula to disperse and bond the fire-retardant particles to the underlying thermal insulating materials. The flammability of the coated thermal insulating materials was tested using a single-flame source test and cone calorimetry. The results showed that sulfonated kraft lignin-coated cellulosic thermal insulating materials had a better fire retardancy compared with that for kraft lignin with a coating weight of 0.8 kg/m2. Nanoclay-coated samples had the best fire retardancy and did not ignite under a heat flux of 25 kW/m2, as shown by cone calorimetry and single-flame source tests, respectively. These cost-efficient and bio-based fire retardants have broad applications for improving fire retardancy of sustainable thermal insulating materials.
1 August 2017 in Nordic Pulp & Paper Research Journal
Article Cellulose-fiber-based insulation materials with improved reaction-to-fire properties was published on August 1, 2017 in the journal Nordic Pulp & Paper Research Journal (volume 32, issue 3).