The paper presents a new solution for sampling rate conversion and processing of harmonic signals with known but possibly varying fundamental frequency. This problem is commonly found in particle accelerators, for tracking the beam signals whose revolution frequency varies during the acceleration ramp. It is also common among many other fields such as speech and music processing, removal of mechanical noises, filtering of biomedical recordings, active crack imaging, etc. The key element in the proposed solution is a new architecture for a Farrow-based resampler, in which the resampling ratio can take any value and can be modified continuously to follow the signal fundamental frequency. The combination of two complementary resamplers creates a processing region where signal synchronous processing is performed. The resampler architecture is optimized for modern FPGA features. It decouples the processing and sampling clocks, and uses a single processing (hardware) clock whose frequency remains fixed. The functional model was migrated to Xilinx System Generator and the overall performance is evaluated with an application that filters a periodic signal whose frequency follows a known linear ramp in the presence of additive white noise.
1 September 2018 in Journal of Physics: Conference Series
Transient beam loading compensation schemes, such as One-Turn-FeedBack (OTFB), require beam synchronous processing (BSP). Swept clocks derived from the RF, and therefore harmonic to the revolution frequency, are widely used in CERN synchrotrons; this simplifies implementation with energy ramping, where the revolution frequency changes. It is however not optimal for state-of-the-art digital hardware that prefers fixed frequency clocks. An alternative to the swept clocking is the use of a deterministic protocol, for example White Rabbit (WR): a fixed reference clock can be extracted from its data stream, while enabling digital distribution of the RF frequency among other data. New algorithms must be developed for BSP using this fixed clock and the digital data transmitted on the WR link. This is the strategy adopted for the SPS Low Level RF (LLRF) upgrade. The paper gives an overview of the technical, technological and historical motivations for such a paradigm evolution. It lists the problems of fixed clock BSP, and presents an innovative solution based on a real-time variable ratio re-sampler for implementing an OTFB with the new fixed clock scheme.
25 November 2020 in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
New projects being implemented or planned at CERN, such as the LHC Injectors Upgrade (LIU), the High-Luminosity LHC (HL-LHC) or the Future Circular Collider (FCC), motivate the change of several architectural paradigms in the Low Level RF systems (LLRF). In the upgraded Super Proton Synchrotron (SPS) LLRF, the distribution of RF, the revolution frequency, settings and synchronization timings will rely on a deterministic link, the White Rabbit (WR), exploiting a distributed topology. The digital electronics (FPGA) will now use a fixed frequency clock extracted locally in each node from this data stream. The paper presents a new solution for algorithms that treat beam-induced perturbations as they must solve the challenge to tune their processing to the instantaneous revolution frequency, Beam Synchronous Processing (BSP). We use dynamic resampling of uniform sampled data as tuning element between a sweeping spectrum and the static processing implemented with fixed frequency clocks. The paper applies the novel Beam Synchronous Processing method to transient beam loading compensation. It presents a One Turn delay FeedBack (OTFB) for the SPS based on a cascade of two variable ratio resamplers.