Lei Xia

Lei Xia

Auto-generated profile, based on publicly available information

Lei Xia

School of Textile Science and Engineering, Tiangong University, Tianjin, China

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
23 September 2019 in Polymers
Verified
Journal Article
Open access
PDF file
LXLei Xia
Lei Xia
QZQuping Zhang
Quping Zhang
XZXupin Zhuang
Xupin Zhuang
SZShuo Zhang
Shuo Zhang
CDChengpu Duan
Chengpu Duan
BCBowen Cheng
Bowen Cheng
In this work, a polyethylene terephthalate (PET) nonwoven support was prepared by wet-laid and hot-press technology and used as support for separation membranes. The properties of the PET nonwoven support were studied to determine the effect of hot-pressing parameters and PET fiber ratio, and were optimized by response surface methodology. Result showed that the PET nonwoven support with 62% low melting point PET (LPET-180) fibers obtained satisfactory properties and structure after hot pressing at 220 °C under the pressure of 9 MPa for 20 s. The response surface analysis indicated that the temperature and time of hot pressing and the fiber ratio were the most important factors affecting the strength and air permeability of the PET nonwoven support. After hot pressing, the PET nonwoven support exhibited interconnected structure, small pore size, low porosity, and high strength. Then phase inversion technique was applied to prepare a polysulfone (PSF) layer on the PET nonwoven support and an ultra-thin polyamide (PA) active layer was prepared by interfacial polymerization on the PSF layer. The practicality of PET nonwoven support was verified by testing the pure water flux and retention of the PA composite membrane and the structural change of the PA composite membrane before and after use. The results proved the feasibility and remarkable application prospects of hot-pressed wet-laid PET nonwoven support as support for separation membranes.

2 February 2016 in Journal of Sol-Gel Science and Technology
Verified
Journal Article
Closed access
PDF file
WXWei Xu
Wei Xu
LXLei Xia
Lei Xia
JJJing-Ge Ju
Jing-Ge Ju
PXPeng Xi
Peng Xi
BCBowen Cheng
Bowen Cheng
YLYu-Xia Liang
Yu-Xia Liang

27 July 2020 in Fibers and Polymers
Verified
Journal Article
Closed access
PDF file
LXLei Xia
Lei Xia
LLLin-Lin Lu
Lin-Lin Lu
YLYu-Xia Liang
Yu-Xia Liang

1 February 2016 in Micro & Nano Letters
Verified
Journal Article
Open access
PDF file
WXWei Xu
Wei Xu
LXLei Xia
Lei Xia
XZXing‐Hai Zhou
Xing‐Hai Zhou
PXPeng Xi
Peng Xi
BCBowen Cheng
Bowen Cheng
YLYu‐Xia Liang
Yu‐Xia Liang
A novel method for preparing coaxial polyacrylonitrile (PAN)/polyvinyl pyrrolidone (PVP) microfibres is proposed. Further, the obtained composite fibres are subsequently processed using pre‐oxidation and carbonisation treatments in order to obtain hollow carbon microfibres. The effects of different respective PVP and PAN concentrations in the inner and outer solutions (the solutions injected into the inner and outer centrifugal tubes, respectively) on the product morphology are discussed. It is found that hollow carbon microfibres can only be fabricated for concurrent inner PVP and outer PAN solution concentrations of 14–17 and 13–16 wt%, respectively. If either of the solution concentrations is too low, droplets are formed, whereas the spinneret becomes blocked and cannot spin if either of these concentrations is too high. The diameters of the coaxial fibres and hollow carbon fibres can be controlled between 3 and 10 μm. This novel coaxial centrifugal spinning strategy can potentially be applied in the rapid fabrication of coaxial and hollow fibres.

22 February 2023 in Fibers and Polymers
Verified
Journal Article
Closed access
PDF file
QDQiuping Du
Qiuping Du
JYJiajing Yu
Jiajing Yu
XXXianlin Xu
Xianlin Xu
LXLei Xia
Lei Xia
XZXupin Zhuang
Xupin Zhuang

2 February 2016 in Collectanea Mathematica
Verified
Journal Article
Closed access
PDF file
YLYu-Xia Liang
Yu-Xia Liang
LXLei Xia
Lei Xia