Department of Dentistry-Biomaterials, Radboud Institute for Molecular Life Sciences, Radboud University Medical Center, Philips van Leydenlaan 25, 6525, EX Nijmegen, the Netherlands
Auto-generated profile, based on publicly available information
Xian Cheng
Department of Dentistry-Biomaterials, Radboud Institute for Molecular Life Sciences, Radboud University Medical Center, Philips van Leydenlaan 25, 6525, EX Nijmegen, the Netherlands
Electrophoretically deposited (EPD) coatings have often been employed recently for the addition of different new chemical compositions to classic chitosan coatings to improve the biocompatibility and therapeutic potential of coated implants. However, little attention has been paid to enhance the cell response to EPD coatings via integrating the effects of chemical components and surface topography. Here, we fabricated EPD chitosan/gelatin (CS/G) coatings with controlled porous surface topography by controlling bubble generation in the EPD process via changing the gelatin content in solution from 0, 0.01, 0.1, and 1 to 10 mg ml−1. The pure chitosan coating surface was characterized by homogeneous large pores of 500 μm. After 0.01 mg ml−1 gelatin was added, 180 μm small pores appeared on the walls of large pores. As the gelatin content increased to 0.1 mg ml−1, a number of small pores increased noticeably. When the gelatin content reached 1 mg ml−1, large pores disappeared, and the coating displayed homogeneous small pores. 10 mg ml−1 gelatin concentration led to coatings consisting of small pores with not integral and continuous structures. The initial osteoblastic responses, including cell adherence progress, spreading area, proliferation rate, and focal adhesion-related gene expression, gradually improved from 0 to 0.01, 0.1, and 1 mg ml−1 gelatin content, but decreased from 1 to 10 mg ml−1. All these results indicated that the initial cell responses to coatings reached a peak when it was 1 mg ml−1 gelatin and they had homogeneous small pores, which might contribute to the synergistic effects of the porous surface structure and components. This work would be beneficial for expanding the potential application of EPD coatings.
1 August 2015 in Materials Science and Engineering: C
Electrophoretically deposited (EPD) polymer-based coatings have been extensively reported as reservoirs on medical devices for delivery of therapeutic agents, but control over drug release remains a challenge. Here, a simple but uncommon assembly strategy for EPD polymer coatings was proposed to improve drug release without introducing any additives except the EPD matrix polymer precursor. The added value of the proposed strategy was demonstrated by developing a novel EPD silk fibroin (SF) coating assembled from pre-assembled SF nanospheres for an application model, i.e. preventing infections around percutaneous orthopedic implants via local delivery of antibiotics. The EPD mechanism of this nanosphere coating involved oxidation of water near the substrate to neutralize SF nanospheres resulting into irreversible deposition. The deposition process and mass could be easily controlled by applied EPD parameters. In comparison with the EPD SF coating assembled by a conventional way (directly obtained from SF molecule solutions), this novel coating had similar adhesion strength but exhibited a more hydrophobic nanotopography to induce better fibroblastic response. Moreover, the use of nanospheres as building blocks enabled 1.38 and 21 times enhancement on antibiotic release amount and time (of 95 % maximum dug release), while retaining drug effectiveness and showing undetectable cytotoxicity. This unexpected release kinetics was found attributable to the electrostatic and hydrophobic interactions between drug and nanospheres, and negligible initial dissolution effect on nanosphere coating. These results illustrate the promising potential of pre-assembled strategy on EPD polymer coatings for superior control over drug delivery.