15 October 2020 in Physical Review Accelerators and Beams
For the past generation storage ring colliders, we usually used natural bunch length or its impedance lengthened value in beam-beam simulations instead of considering the impedance directly. In the future colliders, such as FCC-ee and CEPC, the beam-beam interaction becomes essentially three dimensional. In order to increase the luminosity, the future accelerators will collide very intense beams of high energy with low emittances and small beta functions at the collision points exploiting the crab waist collision scheme with a large Piwinski angle. For these extreme parameters several new effects become important for the collider performance such as beamstrahlung, coherent X-Z instability, 3D flip-flop so that the longitudinal beam dynamics should be also treated in a self-consistent manner. In this paper we describe the numerical code for the self-consistent 3D beam-beam simulations including beamstrahlung and the longitudinal beam coupling impedance and study interplay of different effects arising in beam-beam collisions of the future colliders.
1 February 2016 in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
The High Luminosity LHC project is aimed at increasing the LHC luminosity by an order of magnitude. One of the key ingredients to achieve the luminosity goal is the beam intensity increase. In order to keep beam instabilities under control and to avoid excessive power losses a careful design of new vacuum chamber components and an improvement of the present LHC impedance model are required. Collimators are among the major impedance contributors. Measurements with beam have revealed that the betatron coherent tune shifts were higher by about a factor of 2 with respect to the theoretical predictions based on the LHC impedance model up to 2012. In that model the resistive wall impedance has been considered as the dominating impedance contribution for collimators. By carefully simulating also their geometric impedance we have contributed to the update of the LHC impedance model, reaching also a better agreement between the measured and simulated betatron tune shifts. During the just ended LHC Long Shutdown I (LSI), TCS/TCT collimators were replaced by new devices embedding BPMs and TT2-111R ferrite blocks. We present here preliminary estimations of their broad-band impedance, showing that an increase of about 20% is expected in the kick factors with respect to previous collimators without BPMs.
1 September 2008 in Nuclear Physics B - Proceedings Supplements
15 September 2003 in arXiv
A luminosity of a circular collider can be increased by squeezing the bunch length at the interaction point (IP). A natural way to decrease the bunch length is to decrease the momentum compaction factor and/or to increase the RF voltage. However, in such a way we cannot obtain short bunches with high currents since wakefields prevent this due to the potential well distortion and the microwave instability. In present paper we propose to use a strong RF focusing (with high RF voltage and high momentum compaction factor) to obtain very short bunches at the IP with progressive bunch elongation towards the RF cavity. This allows placing the most important impedance generating elements near the RF cavity where the bunch is longest thus minimizing the effect of the wakefields.