An essential capability in many applications, ranging from commercial, surveillance and defense, is to analyze the spectral content of intercepted microwave and millimeter-wave signals over a very wide bandwidth in real-time and with high resolution. A range of photonic schemes have been introduced for the real-time processing of wideband signals to overcome limitations of current conventional electronic frequency measurement approaches. Here, a novel microwave/millimeter-wave channelizer is presented based on a RF photonic front-end employing parametric wavelength multicasting and comb generation. This new technology enables a contiguous bank of channelized coherent I/Q IF signals covering extremely wide RF instantaneous bandwidth. High channel counts and wide RF instantaneous bandwidth are enabled by use of parametrically generated frequency-locked optical combs spanning >4 THz. Full field analysis capabilities of the coherent detection system are demonstrated by frequency domain analysis of 18 contiguous 1.2 GHz IF channels covering 15.5 GHz to 37.1 GHz input frequency range, and time and spectral domain analysis of a 75 GHz harmonically generated input signal. Sensitivity and dynamic range of the system are analyzed and discussed.
A 75 nm wide parametric frequency comb with 6.25 GHz frequency grid is used for 31.8 Tb/s coherent transmission of 1520 Nyquist UDWDM channels, offering up to 30 Gb/s per user over a 50 km of regular single mode fiber.
A high quality cavity-less pulse source, realized as a combination of linear pulse compression and self-phase-modulation (SPM) based regeneration is demonstrated and strictly characterized for the first time. The regenerated pulses, with 3.6 GHz repetition rate, are optimized through rigorous relative intensity-noise (RIN) measurement. Temporal intensity and chirp characterizations demonstrate that the pulses exhibit characteristic of low RIN, and are chirp- and pedestal-free. The cavity-less pulse source is further tested in a photonic-assisted analog-to-digital (ADC) configuration as the sampling source. A record result of more than 8 effective quantization bits at 202 MHz is demonstrated.
Stable four-mode phase-sensitive (4MPS) process was investigated as a means to enhance two-pump driven parametric multicasting conversion efficiency (CE) and signal to noise ratio (SNR). Instability of multi-beam, phase sensitive (PS) device that inherently behaves as an interferometer, with output subject to ambient induced fluctuations, was addressed theoretically and experimentally. A new stabilization technique that controls phases of three input waves of the 4MPS multicaster and maximizes CE was developed and described. Stabilization relies on digital phase-locked loop (DPLL) specifically was developed to control pump phases to guarantee stable 4MPS operation that is independent of environmental fluctuations. The technique also controls a single (signal) input phase to optimize the PS-induced improvement of the CE and SNR. The new, continuous-operation DPLL has allowed for fully stabilized PS parametric broadband multicasting, demonstrating CE improvement over 20 signal copies in excess of 10 dB.
13 January 2015 in Journal of Lightwave Technology
Phase manipulation of four-mode phase-sensitive (4MPS) process was developed as a means for suppression of high-order four wave mixing (HoFWM) terms in dual-pump driven parametric wavelength multicasting and, consequently, for reduction of inter-channel crosstalk and inter-channel interference. In contrast to the previous studies that focused on power stabilization and conversion efficiency maximization, the investigation in this paper focuses on the evolution of the inter-channel HoFWM tones, whose suppression can be accomplished by arranging the phases of signals in a complementary manner. In addition, broadband 4MPS multicasting with suppressed HoFWM effects over 100-nm bandwidth, reaching up to 12-dB suppression ratio was demonstrated.