21 August 2023 in Applied Physics Letters
In this study, we analytically, numerically, and experimentally investigated a high-performance confocal piezoelectric energy harvesting system. We achieved a significantly enhanced electrical performance through a Mikaelian lens, which achromatically focuses ambient elastic waves, resulting in the formation of a highly amplified strain energy field in the piezoelectric energy harvester. Previous studies on piezoelectric energy harvesting platforms have limitations, such as the focal position changing with operating frequencies and impedance mismatching owing to inclusions or holes. To address these problems, we utilized the self-focusing ability based on the conformal mapping theory and achromatic ability based on the Kirchhoff–Love thin plate theory to design our Mikaelian lens-based piezoelectric energy harvesting platform. The proposed platform demonstrates a remarkable elastic wave focusing ability at an identical focal position for a broad frequency range. The experimentally visualized wave fields matched well with the numerically calculated full-wave harmonic simulation results. We achieved highly amplified output power up to 1.44 mW within a broad range from 40 to 60 kHz out of the same focal point owing to confined elastic wave energy; the output power extracted at this confocal position was up to 3.76 times higher than that extracted at the lens start position. Our highly performance and broadband achromatic piezoelectric energy harvesting platform lays an attractive foundation for designing potential applications, such as wireless sensing, structural health monitoring, and biomedical devices.
16 December 2021 in Journal of Applied Physics
This investigation presents a new measurement technique for third-order elastic constants using the acoustoelastic effect. The cross-sectional resonance frequencies of a cylindrical rod are measured while the rod is stressed under tensional load. The Murnaghan's third-order elastic constants of the rod are determined by matching experimentally obtained resonance frequencies with those numerically obtained by a finite element model. Electromagnetic acoustic transducers (EMATs) are employed to measure cross-sectional resonance frequencies, enhancing the repeatability to minimize the variation of the contact condition between the transducer and the specimen. The present method was applied to specimens made of carbon steel (JIS-S20C) and aluminum (Al7075-T651), whose third-order elastic constants were calculated. It should be emphasized that the estimated Murnaghan's constants obtained by the proposed method showed very small coefficients of variation (CVs), less than 6.54%, for repeated tests conducted on several specimens, showing excellent repeatability and reproducibility that is almost unattainable by conventional methods using wave speeds or higher harmonics of an input wave.