19 October 2010 in Radiation Protection Dosimetry
To estimate the radiation risk of astronauts during space missions, it is necessary to measure dose characteristics in various compartments of the spacecraft; this knowledge can be further used for estimating the health hazard in planned missions. This contribution presents results obtained during several missions on board the International Space Station (ISS) during 2005–09. A combination of thermoluminescent and plastic nuclear track detectors was used to measure the absorbed dose and dose equivalent. These passive detectors have several advantages, especially small dimensions, which enabled their placement at various locations in different compartments inside the ISS or inside the phantom. Variation of dosimetric quantities with the phase of the solar cycle and the position inside the ISS is discussed.
1 September 2020 in Radiation Measurements
11 October 2023 in Radiation Protection Dosimetry
When primary space radiation particles enter into the atmosphere of the Earth, they generate showers of secondary radiation. The intensity of secondary radiation reaches its maximum, called the Regener–Pfotzer maximum; its exact position depends on the geomagnetic effective vertical cut-off rigidity, the phase of the solar cycle and also on the type of detected particles. In this paper, several balloon flight experiments are described focusing on the study of the latitudinal effect on the position of the Regener–Pfotzer maximum. Altitude profile of ionization in the atmosphere was measured using radiation detectors flown during several flights at locations with different effective vertical cut-off rigidities (flight HEMERA over Sweden and flights FIK-5 and FIK-6 over Czech Republic). The measured results are supplemented also with simulations using EXPACS 4.11 and the variation of obtained positions of Regener–Pfotzer maximum is discussed.
7 November 2019 in Radiation Protection Dosimetry
KBKateřina Pachnerová Brabcová
Kateřina Pachnerová Brabcová
VSVyacheslav A Shurshakov
Track-etched detectors are commonly used also for radiation monitoring onboard International Space Station. To be registered in track-etched detectors, the particle needs to meet several criteria—it must have linear energy transfer above the detection threshold and strike the detector’s surface under an angle higher than the so-called critical angle. Linear energy transfer is then estimated from calibration curve from the etch rate ratio V that is calculated from parameters of individual tracks appearing on the detector’s surface after chemical etching. It has been observed that V can depend on the incident angle and this dependence can vary for different detector materials, etching and evaluating conditions. To investigate angular dependence, detectors (Harzlas TD-1) were irradiated at HIMAC by several ions under angles from 0° to 90°. The correction accounting not only for critical angle but also for dependence of V on the incident angle is introduced and applied to spectra measured onboard International Space Station.
1 November 2025 in Physica Medica
28 October 2025 in Journal of Geophysical Research: Space Physics
The production, attenuation, and absorption of secondary cosmic rays (SCR) are influenced by atmospheric parameters such as air pressure and temperature. To reliably correlate SCR flux measurements with atmospheric ionization driven by energetic particle precipitation, these dependencies must be quantified. Monte Carlo simulations enable detailed modeling of stochastic interactions between cosmic radiation and atmospheric components, providing a robust framework for analyzing underlying physical processes and predicting SCR flux under varying atmospheric conditions. This study introduces a simulation model based on the Monte Carlo N‐Particle (MCNP) code, integrating atmospheric profiles from radiosonde data to model the production, absorption, and attenuation of SCR. The model's accuracy was validated through comparisons with the PHITS (Particle and Heavy Ion Transport code System)‐based Analytical Radiation Model in the Atmosphere (PARMA) and experimental ground‐based muon count measurements. It was subsequently used to investigate the dependence of muon flux on atmospheric pressure and temperature up to 20 km altitude. Results reveal a complex relationship between muon flux and atmospheric variables, particularly in the troposphere and lower stratosphere, where pressure correlations and barometric coefficients exhibit both positive and negative values depending on altitude. The model provides a valuable tool for investigating interactions between SCR and climate variables such as humidity and cloud coverage. Furthermore, the model can be coupled with dosimetry models to assess the biological effects of SCR, including deoxyribonucleic acid (DNA) damage, genomic instability, cellular dysfunction, and long‐term health risks such as cancer.