Institute of Materials for Electronics and Energy Technology (I-MEET), Department of Materials Science and Engineering, Friedrich-Alexander University Erlangen-Nuremberg, 91058 Erlangen, Germany
Auto-generated profile, based on publicly available information
Ievgen Levchuk
Institute of Materials for Electronics and Energy Technology (I-MEET), Department of Materials Science and Engineering, Friedrich-Alexander University Erlangen-Nuremberg, 91058 Erlangen, Germany
Minimizing losses at interfaces: Among the issues facing the practical use of hybrid organohalide lead perovskite solar cells is the loss of charge carriers at interfaces. Hou et al. show that tantalum-doped tungsten oxide forms almost ohmic contacts with inexpensive conjugated polymer multilayers to create a hole-transporting material with a small interface barrier. This approach eliminates the use of ionic dopants that compromise device stability. Solar cells made with these contacts achieved maximum efficiencies of 21.2% and operated stably for more than 1000 hours. Science , this issue p. 1192
We present quantum size-confined colloidal CH3NH3PbX3 (X = Br and I) perovskite nanoplatelets with remarkably high photoluminescence quantum yield up to 90%.
22 October 2015 in Journal of Materials Chemistry A
While perovskite-based semitransparent solar cells deliver competitive levels of transparency and efficiency to be envisioned for urban infrastructures, the complexity and sensitivity of their processing conditions remain challenging. Here, we introduce two robust protocols for the processing of sub-100 nm perovskite films, allowing fine-tuning of the active layer without compromising the crystallinity and quality of the semiconductor. Specifically, we demonstrate that a method based on solvent-induced crystallization with a rapid drying step affords perovskite solar cells with 37% average visible transmittance (AVT) and 7.8% PCE. This process enhances crystallization with a preferential phase orientation presumably at the interface, yielding a high fill factor of 72.3%. The second method is based on a solvent–solvent extraction protocol, enabling active layer films as thin as 40 nm and featuring room-temperature crystallization in an ambient environment on a few second time span. As a result, we demonstrate a maximum AVT of 46% with an efficiency of 3.6%, which is the highest combination of efficiency and transparency for a full device stack to date. By combining the two methods presented here we cover a broad range of thicknesses vs. transparency values and confirm that solvent-induced crystallization represents a powerful processing strategy toward high-efficiency semitransparent solar cells. Optical simulations support our experimental findings and provide a global perspective of the opportunities and limitations of semitransparent perovskite photovoltaic devices.
17 July 2019 in ACS Applied Materials & Interfaces
Metal halide perovskite semiconductors have the potential to enable low-cost, flexible, and efficient solar cells for a wide range of applications. Physical vapor deposition by co-evaporation of precursors is a method that results in very smooth and pinhole-free perovskite thin films and allows excellent control over film thickness and composition. However, for a deposition method to become industrially scalable, reproducible process control and high device yields are essential. Unfortunately, to date, the control and reproducibility of evaporating organic precursors such as methylammonium iodide (MAI) have proved extremely challenging. We show that the established method of controlling the evaporation rate of MAI with quartz microbalances (QMBs) is critically sensitive to the concentration of the impurities MAH2PO3 and MAH2PO2 that are usually present in MAI after synthesis. Therefore, controlling the deposition rate of MAI with QMBs is unreliable since the concentration of such impurities typically varies from one batch of MAI to another and even during the course of a deposition. However once reliable control of MAI deposition is achieved, we find that the presence of precursor impurities during perovskite deposition does not degrade the solar cell performance. Our results indicate that as long as precursor deposition rates are well controlled, physical vapor deposition will allow high solar cell device yields even if the purity of precursors changes from one run to another.