Air entrapment in soil is common in cases of farmland flood irrigation or intense rain. A simple, physically based model would be more useful than the complex two-phase (gaseous and liquid phase) flow model to describe water infiltration in layered soils with air entrapment. This study proposed a modified Green-Ampt model (MGAM) to simulate water infiltration in layered soils with consideration of entrapped air. A saturation coefficient was introduced in MGAM to account for the resistance effect of air entrapment on infiltration. had robust physical meaning, and was approximately equal to one minus the plus of the residual air and residual water saturation degree that could be determined from the soil water retention curve equation. In MGAM, the actual water content and hydraulic conductivity of the wetted zone were determined by multiplying with the saturated values. Infiltration experiments in a 300-cm-long five-layered soil column and a 280-cm-deep eight-layered field soil profile were conducted to test the applicability of MGAM. For comparison, the infiltration process was also simulated by the traditional Green-Ampt model (TGAM), in which the wetted zone was assumed to be fully saturated, and the Bouwer Green-Ampt model (BGAM), in which the hydraulic conductivity of the wetted zone was half that of the saturated hydraulic conductivity. The estimated values were very close to the measured saturation degree of soil layers at the termination of the experiment. The simulation results indicated that the TGAM overestimated the infiltration rate and cumulative infiltration, whereas the BGAM underestimated the infiltration rate and cumulative infiltration. Furthermore, the depths of the wetting fronts simulated by TGAM and BGAM were considerably smaller than those measured. The MGAM provided satisfactory simulation results and adequately described the infiltration process in both the laboratory soil column and the field soil profile.
1 September 2009 in Journal of Hydrologic Engineering
This study uses the mobile-immobile model (MIM) and the traditional convection-dispersion equation (CDE) to analyze the observed breakthrough curves (BTCs) at different distances in a 1,250-cm-long saturated and highly heterogeneous soil column. It provides a simple method to determine the mobile water fraction independently as the ratio of effective porosity over total porosity of the packed soil materials. The effective porosity is calculated a priori as the ratio of measured flow rate and estimated pore-water velocity. It is found that there is a significant amount of immobile water in the soil column, resulting in the anomalous early breakthrough and tailing behaviors of the measured BTCs. Comparing to the CDE, the measured asymmetric BTCs at various scales can be better described by the MIM, especially their early arrival and long tailing parts. The degree of anomalous transport behavior in this large heterogeneous soil column is reduced with transport scale due to the increased mobile water fraction...
26 January 2010 in Wuhan University Journal of Natural Sciences
An experiment was conducted in non-weighing lysimeters to study the effect of irrigation with saline water on water movement and salt accumulation and maize yield. The experiment was carried out in northwest China, both sufficient and insufficient irrigation were applied in the first year, and only sufficient treatments in the second year. Irrigation with solute concentration of 9 g · L−1 and 6 g · L−1 led to salt accumulation about 6–8 dS · m−1 in certain depths, even downwards to 160 cm received about 4 dS · m−1 for 9 g · L−1 and 2 dS · m−1 for 6 g · L−1, which was two times more than initial. Salt-affected water extracted from soil behaved as low evapotranspiration under sufficient irrigation, and more water was left in the soil. Yield of spring maize was not affected when saturated soil paste electrical conductivity did not exceeded 1.2 dS · m−1.