Ultra-small crystals of undoped and Eu-doped gadolinium oxide (Gd2O3) were synthesised by a simple, rapid microwave-assisted route, using benzyl alcohol as the reaction solvent. XRD, XPS and TEM analysis reveal that the as-prepared powder material consists of nearly monodisperse Gd2O3 nanocrystals with an average diameter of 5.2 nm. The nanocrystals show good magnetic behaviour and exhibit a larger reduction in relaxation time of water protons than the standard Gd–DTPA complex currently used in MRI imaging. Cytotoxicity studies (both concentration- and time-dependent) of the Gd2O3 nanocrystals show no adverse effect on cell viability, evidencing their high biological compatibility. Finally, Eu:Gd2O3 nanocrystals were prepared by a similar route and the red luminescence of Eu3+ activator ions was used to study the cell permeability of the nanocrystals. Red fluorescence from Eu3+ ions observed by fluorescence microscopy shows that the nanocrystals (Gd2O3 and Eu:Gd2O3) can permeate not only the cell membrane but can also enter the cell nucleus, rendering them candidate materials not only for MRI imaging but also for drug delivery when tagged or functionalized with specific drug molecules.
Chitosan is a biodegradable, biocompatible and extracellular matrix mimicking polymer. These tunable biological properties make chitosan highly useful in a wide range of applications like tissue-engineering, wound dressing material, controlled drug delivery system, biosensors and membrane separators, and as antibacterial coatings etc. Moreover, its similarity with glycosaminoglycans makes its suitable candidate for tissue-engineering. Electrospinning is a novel technique to manufacture nanofibers of chitosan and these nanofibers possess high porosity and surface area, making them excellent candidates for biomedical applications. However, lack of mechanical strength and water insolubility make it difficult to fabricate chitosan nanofibers scaffolds. This often requires blending with other polymers and use of harsh solvents. Also, the functionalization of chitosan with different chemical moieties provides a solution to these limitations. This article reviews the recent trends and sphere of application of chitosan nanofibers produced by electrospinning process. Further, we present the latest developments in the functionalization of this polymer to produce materials of biological and environmental importance.
5 February 2014 in Journal of Materials Chemistry C
We report a novel, rapid, and low-temperature method for the synthesis of undoped and Eu-doped GdOOH spherical hierarchical structures, without using any structure-directing agents, through the microwave irradiation route. The as-prepared product consists of nearly monodisperse microspheres measuring about 1.3 μm in diameter. Electron microscopy reveals that each microsphere is an assembly of two-dimensional nanoflakes (about 30 nm thin) which, in turn, result from the assembly of crystallites measuring about 9 nm in diameter. Thus, a three-level hierarchy can be seen in the formation of the GdOOH microspheres: from nanoparticles to 2D nanoflakes to 3D spherical structures. When doped with Eu3+ ions, the GdOOH microspheres show a strong red emission, making them promising candidates as phosphors. Finally, thermal conversion at modest temperatures leads to the formation of corresponding oxide structures with enhanced luminescence, while retaining the spherical morphology of their oxyhydroxide precursor.
1 December 2013 in Materials Chemistry and Physics
Nanocrystalline ZnGa2O4 spinel powders were prepared through a simple and facile microwave-irradiation assisted solution-based route, using ethylene glycol as the reaction medium and, without using any structure-directing agents. The as-prepared product consists of ZnGa2O4 nanoparticles, which are crystalline as revealed by X-ray diffraction studies and TEM analysis. Transmission electron microscopy (TEM) and scanning electron microscopy (SEM) studies also show that, the size of these as-prepared nanoparticles is less than 10 nm. The annealed nanopowders show intense blue luminescence, under UV excitation, which makes these nanopowders important in the field of phosphor applications.