20 November 2018 in New Journal of Chemistry
Here we demonstrate the mechanical energy harvesting performance of a poly(vinylidene-fluoride) (PVDF) device which is loaded with reduced graphene oxide–silver nanoparticles (rGO–Ag). The current results show that the addition of rGO–Ag enhances the polar beta and gamma piezoelectric phases in PVDF, which is capable of generating a greater piezoelectric output, thereby eliminating the requirement of any external poling process. X-ray diffraction (XRD) and Fourier transform infra-red spectroscopy (FT-IR) characterizations were employed for the identification and quantification of the piezoelectric polar phases of the nanocomposite films. Raman spectroscopy confirmed the interactions between rGO–Ag and PVDF. Polarization vs. electric field (P–E) loop testing was performed and it was found that on the application of an external electric field of 148 kV cm−1 the nanocomposite showed an energy density value of ∼0.26 J cm−1, which indicates its potential for energy storage applications. The fabricated energy harvesting device, a piezoelectric nanogenerator (PNG), could charge up capacitors and light up to 20 commercial blue light-emitting diodes. The PNG was tested to harvest biomechanical energy from pulsing mechanical energy by fixing it to fingers on the human palm. The PNG was also fixed to flip-flops in order to demonstrate its footwear connected energy harvesting application. The PNG showed a peak output open circuit voltage of ∼18 V and a short circuit current of ∼1.05 μA, with a peak power density of 28 W m−3 across a 1 MΩ resistor. The PNG shows a moderate efficiency of 0.65%.
1 March 2019 in Applied Surface Science
1 February 2019 in Electrochimica Acta
27 August 2018 in ACS Sustainable Chemistry & Engineering
8 December 2017 in Nanoscale
High performance battery behaviour (left panel) of mesoporous layered hexagonal platelets (middle panel) composed of highly crystalline Co3O4 nanoparticles with (111) facets (right panel) in an aqueous electrolyte of 2 M KOH.
16 October 2019 in Journal of the Electrochemical Society
Porous spherical bundles of W18O49 nanorods with rich oxygen vacancy has been generated by a facile, low cost solvothermal approach and subsequently characterized for energy storage application. The remarkable electrochemical activity of W18O49 nanostructure is referred to the development of oxygen vacancy and nanostructure network leading to maximize the active sites and surface area for the electrolyte ions. A specific capacity of 470 mA h /g at scan rate of 1mV/s and 452 mA h /g at a very high current density of 1.25 A/g were calculated in 1M H2SO4 electrolyte. The experimental results revealed that surface oxygen vacancy enhances the adsorption and reaction site for electrolyte ions indicating the good electrochemical activity of the W18O49 nanostructure materials. GCD summarizes an intermediate mechanism of pseudocapacitor–battery for W18O49 nanorods. These findings will have a profound effect on understanding and mechanism of the surface induced vacancy to the process of electrochemical activity in terms of energy storage.