22 December 2022 in Системи обробки інформації
Запропоновано класифікацію викривлень поточних зображень у матричних радіометричних кореляційно-екстремальних системах наведення літальних апаратів. Показано вплив різних видів викривлень поточного зображення та наведена оцінка цього впливу на значення імовірності правильної прив’язки алгоритму суміщення зображень. Наголошено необхідність врахування комплексного впливу викривлень під час моделювання процесу прив’язки літального апарату. Для зниження впливу таких дестабілізуючих факторів наведені практичні рекомендації.
9 June 2023 in Grail of Science
В роботі проведено оцінювання впливу матеріалу ізоляції проводу на його температуру нагрівання в процесі експлуатації. Визначено діапазони підвищення температури проводу в процесі експлуатації для проводу з ізоляцією з поліетилену, ПВХ, емалі та гуми.
20 February 2026 in Grail of Science
Концепція створення системи психологічної підтримки персоналу ЗС України, затверджена Головнокомандувачем (ГК) Збройних Сил (ЗС) України 18.11.2023, визначила сукупність взаємопов’язаних положень, ідей та поглядів щодо шляхів трансформації існуючої у Збройних Силах (ЗС) України системи морально-психологічного забезпечення (МПЗ) у нову систему – психологічну підтримку персоналу (ППП) ЗС України.
1 October 2025 in Наукові праці Державного науково-дослідного інституту випробувань і сертифікації озброєння та військової техніки
The influence of the chemical composition of the conductive core of an insulated electric wire with single-layer isolation on its heating temperature depending on the operating time at different load currents is investigated. An improved mathematical model was used, which allows us to estimate the temperature increase of a single-core electric wire with the time of operation. The calculations were carried out using computer equipment in the MATHCAD software package for a copper conductor with impurities of iron, cobalt, and manganese in different proportions. For example, the temperature-time dependences for the PVC1 2.5 (H05V-U 2.5) electric wire were built for load currents less than, equal to, and greater than the maximum permissible values. The analysis of the obtained temperature-time characteristics made it possible to state that the heating temperature of electric wires during their operation is significantly determined by the impurity material of the copper conductor. The paper shows that the temperature-time characteristics of PVC1 2,5 (H05V-U 2,5) electric wires with different materials of copper conductor impurities have approximately the same nonlinear character at load currents of 20, 30 and 40 A. The simulation results show that for materials of iron, cobalt, manganese impurities to copper, the highest heating temperature for load currents of 20, 30 and 40 A is achieved by electric wires PVC1 2,5 (H05V-U 2,5) with an iron impurity, and the lowest - with a manganese impurity. It is shown that the heating temperature of an electric wire depends significantly on the number of impurities in the conductor material - as the number of impurities increases, the temperature rises. Therefore, the heating temperature of electric wires with different volumes of impurities in the conductor material will differ significantly. At the same time, a tendency was observed to increase the difference between the heating temperatures of electric wires with an increase in the volume of various impurities in the materials of conductive cores for all values of the load current. It was concluded that modeling allows to determine the time during which PVC1 2.5 (H05V-U 2.5) electric wires with various impurities in the conductor material heat up to critical temperatures.
25 November 2021 in Наука і техніка Повітряних Сил Збройних Сил України
В статті розглядаються основи побудови, зберігання, відтворення, синхронізації та передачі розміру одиниці часу та частоти для військових користувачів. Порівнюються методи синхронізації сигналів статичних та динамічних стандартів за основними джерелами похибок, видами синхросигналів, алгоритмами порівняння, апаратурною реалізацією. Високі темпи вдосконалення еталонів часу і частоти, їх відносна нестабільність визначає актуальність підвищення точності опорних генераторів та удосконалення методів синхронізації. Аналізуються параметри нестабільності фази сигналу синхронізації від автономних стандартів частоти та глобальних навігаційних супутникових систем. Обґрунтовується вибір методу двосторонньої передачі сигналів часу та частоти як найбільш прецизійного.