1 July 2010 in AIAA Journal
A novel approach to the development of a hybrid prediction methodology for jet noise is described. Modeling details and numerical techniques are optimized for each of the three components of the model. Far-field propagation is modeled by solution of a system of adjoint linear Euler equations, capturing convective and refraction effects using a spatially developing jet mean flow provided by a Reynolds-averaged Navierâ\u80\u93Stokes computational fluid dynamics solution. Sound generation is modeled following Goldsteinâ\u80\u99s acoustic analogy, including a Gaussian function model for the two-point cross correlation of the fourth-order velocity fluctuations in the acoustic source. Parameters in this model describing turbulent length and time scales are assumed to be proportional to turbulence information also taken from the Reynolds-averaged Navierâ\u80\u93Stokes computational fluid dynamics prediction. The constants of proportionality are, however, not determined empirically, but extracted by comparison with turbulence length and time scales obtained from a large eddy simulation prediction. The large eddy simulation results are shown to be in good agreement with experimental data for the fourth-order two-point cross-correlation functions. The large eddy simulation solution is then used to determine the amplitude parameter and also to examine which components of the cross correlation are largest, enabling inclusion of all identified dominant terms in the Gaussian source model. The acoustic source description in the present approach is therefore determined with no direct input from experimental data. This model is applied to the prediction of sound to the experimental configuration of the European Union JEAN project, and gives encouraging agreement with experimental data across a wide spectral range and for both sideline and peak noise angles. This paper also examines the accuracy of various commonly made simplifications, for example: a locally parallel mean flow approximation rather than consideration of the spatially evolving mean jet flow and scattering from the nozzle; the assumption of small radial variation in Green function over the turbulence correlation length; the application of the far-field approximation in the Green function; and the impact of isotropic assumptions made in previous acoustic source models
1 February 1999 in AIAA Journal
2 March 2007 in Flow, Turbulence and Combustion
1 July 2012 in Progress in Aerospace Sciences
With increasing computing power, Large Eddy Simulation could be a useful simulation tool for gas turbine axial compressor design. This paper outlines a series of simulations performed on compressor geometries, ranging from a Controlled Diffusion Cascade stator blade to the periodic sector of a stage in a 3.5 stage axial compressor. The simulation results show that LES may offer advantages over traditional RANS methods when off-design conditions are considered – flow regimes where RANS models often fail to converge. The time-dependent nature of LES permits the resolution of transient flow structures, and can elucidate new mechanisms of vorticity generation on blade surfaces. It is shown that accurate LES is heavily reliant on both the near-wall mesh fidelity and the ability of the imposed inflow condition to recreate the conditions found in the reference experiment. For components embedded in a compressor this requires the generation of turbulence fluctuations at the inlet plane. A recycling method is developed that improves the quality of the flow in a single stage calculation of an axial compressor, and indicates that future developments in both the recycling technique and computing power will bring simulations of axial compressors within reach of industry in the coming years
1 March 2001 in Proceedings of the Institution of Mechanical Engineers, Part G: Journal of Aerospace Engineering
The objective of this work is to model underexpanded turbulent sonic jets. A pressure-based computational fluid dynamics methodology has been employed, incorporating extensions to handle high speed flows. A standard two-equation turbulence model is used, with an optional compressibility correction. Comparison with experimental jet centre-line Mach number showed the correct shock cell wavelength but a too rapid decay. The compressibility correction had no effect on the shock cell decay but increased the potential core length to give better agreement with experiment. Calculations for nozzle pressure ratios up to 30 showed the variation of Mach disc location in good agreement with experiment. For nozzle pressure ratios above 6, unsteady solutions were observed, emanating from the intersection of the Mach disc with the shear layer. Experimental work has identified similar large-scale instabilities; the peak mode of the prediction had a Strouhal number of 0.16, close to experimental values.
1 October 1990 in AIAA Journal