The ionization fraction is a key figure of merit for optimizing the performance of plasma device. This work presents an optical emission spectroscopy (OES) method to determine the ionization fraction in low-temperature xenon plasma. The emission line-ratio of xenon ionic and atomic 6p–6s transitions is used in this method. A comprehensive collisional-radiative model developed in our previous work is employed to describe the relationship between the line-ratios and the plasma parameters. It is found that some special line-ratios have a sensitive relationship to the ionization fraction, e.g. the ratio of the 460.30 nm line and 828.01 nm lines. These line-ratios are selected for the diagnostic method. The method is demonstrated in a magnetized discharge chamber. The axially-resolved emission spectra of the ionization chamber are measured, and from those the ionization fraction along the chamber axis is determined via the OES method. The axially-resolved ionization fraction is found to be dependent on the magnetic field and agrees well with those obtained from a Langmuir probe. In the experiment, the probe is overheated under some conditions, possibly due to the bombardment by energetic particles. In this case, no results can be obtained from the probe, while the OES method can still obtain reasonable results. Combined with optical tomography and spectral imaging technology, the OES method can also provide the spatial distribution of the ionization fraction, which is needed for revealing the discharge mechanisms of plasma devices.
Space-borne gravitational wave (GW) detection spacecraft works in the state of drag free for which a disturbance reduction system is utilized to offset the non-conservative force. The key actuator of drag-free control loop is a micro-thruster with the performance of a high precision thrust and wide-range operations. Ion thruster, such as electron cyclotron resonance ion thruster (ECRIT), is one of the options because its thrust can be controlled precisely by the method of beam current feedback. However, there is still a barrier for the conventional ECRIT to achieve the low thrust of 1 μN as required in space-borne GWs detection missions due to its radial structure. In this work, a minimized ECR ion thruster (mini-ECRIT) is designed by a new idea that it employs an axial ring-cusped field to exploit the low-pressure adaptability of resonance heating. The mini-ECRIT is tested and results in a dynamic thrust range of 1–100 μN, a resolution of 0.1 μN, a thrust noise of 0.1 μN/Hz1/2, and a response time of about 10 ms. In addition, the specific impulse of this thruster can reach as high as 510 s at low thrust 5 μN, being higher than that of previous ion thrusters by a factor of about 5, which may significantly reduce the propellant consumption. This minimized ECR ion thruster may support China’s space-borne GW detection missions such as TianQin.
Space-based gravitational wave detection missions require precise thrusts over a wide-range of 1–100 μN. In this study, the axial ring-cusp magnetic field configuration is used to design a miniature electron cyclotron resonance ion thruster with a radius of 5 mm. Two typical configurations, i.e., open-type and closed-type, are compared in terms of electron density, electron temperature, and thrust for micro-Newton and wide-range operations. The results show that the open-type achieves high performances owing to the high efficiency of absorption of input microwave power. The lower limit of the mass flow rate in the electron cyclotron resonance (ECR) discharge is expanded to a very low value of 3 × 10−2 sccm to achieve 1 μN in the open-type. The thrust in the open-type could be tuned in a wide-range of 1–119 μN, meeting the requirement.