Separation of bulk tungsten disulfide (or WS2) into few-layer two-dimensional (2-D) crystals is of interest because of their high surface area for certain chemical processes and size-dependent optical and electronic characteristics. Herein, we demonstrate a process that involves the physical separation of weakly bonded WS2 layers by use of a strong acid treatment (chlorosulfonic acid) at 2 mg/mL, followed by quenching in deionized (DI) water. X-ray photoelectron spectroscopy of the superacid-treated WS2 suggests the formation of W–O type bonds, signifying oxidation of tungsten and reduction of the sulfur phase. Thermogravimetric analysis showed a three-phase weight-loss pattern, suggesting acid functionalization of WS2 surfaces. We also studied the electrochemical behavior of an acid-treated WS2 anode in a lithium half-cell configuration that showed a three-step charge–discharge behavior, characteristic of a conversion reaction. The electrochemical capacity was 118 mAh/g after 50 cycles.
Silicon and graphene are promising anode materials for lithium-ion batteries because of their high theoretical capacity; however, low volumetric energy density, poor efficiency and instability in high loading electrodes limit their practical application. Here we report a large area (approximately 15 cm × 2.5 cm) self-standing anode material consisting of molecular precursor-derived silicon oxycarbide glass particles embedded in a chemically-modified reduced graphene oxide matrix. The porous reduced graphene oxide matrix serves as an effective electron conductor and current collector with a stable mechanical structure, and the amorphous silicon oxycarbide particles cycle lithium-ions with high Coulombic efficiency. The paper electrode (mass loading of 2 mg cm−2) delivers a charge capacity of ∼588 mAh g−1electrode(∼393 mAh cm−3electrode) at 1,020th cycle and shows no evidence of mechanical failure. Elimination of inactive ingredients such as metal current collector and polymeric binder reduces the total electrode weight and may provide the means to produce efficient lightweight batteries.
The energy density of current lithium-ion batteries (LIBs) based on layered LiMO2 cathodes (M = Ni, Mn, Co: NMC; M = Ni, Co, Al: NCA) needs to be improved significantly in order to compete with internal combustion engines and allow for widespread implementation of electric vehicles (EVs). In this report, we show that atomic layer deposition (ALD) of titania (TiO2) and alumina (Al2O3) on Ni-rich FCG NMC and NCA active material particles could substantially improve LIB performance and allow for increased upper cutoff voltage (UCV) during charging, which delivers significantly increased specific energy utilization. Our results show that Al2O3 coating improved the NMC cycling performance by 40% and the NCA cycling performance by 34% at 1 C/−1 C with respectively 4.35 V and 4.4 V UCV in 2 Ah pouch cells. High resolution TEM/SAED structural characterization revealed that Al2O3 coatings prevented surface-initiated layered-to-spinel phase transitions in coated materials which were prevalent in uncoated materials. EIS confirmed that Al2O3-coated materials had significantly lower increase in the charge transfer component of impedance during cycling. The ability to mitigate degradation mechanisms for Ni-rich NMC and NCA illustrated in this report provides insight into a method to enable the performance of high-voltage LIBs.
18 November 2014 in The Journal of Physical Chemistry C