16 June 2025 in Biochemical Engineering Journal
17 August 2021 in Geophysics
Complex electrical conductivity is increasingly used to monitor subsurface processes associated with microbial activities because microbial cells mostly have surface charges and thus electrical double layers. Although highly saline environments are frequently encountered in coastal and marine sediments, there are limited data available on the complex conductivity associated with microbial activities under a high-salinity condition. Therefore, we have developed the spectral responses of complex conductivity of sand associated with bacterial growth and biofilm formation under a highly saline condition of approximately 1% salinity and approximately 2 S/m pore water conductivity with an emphasis on relaxation behavior. A column test is performed, in which the model bacteria Shewanella oneidensis MR-1 are stimulated for cell growth and biofilm formation in a sand pack, whereas the complex conductivity is monitored from 0.01 Hz to 10 kHz. The test results indicate that the real conductivity increases in the early stage due to the microbial metabolites and the increased surface conduction with cell growth but soon begin to decrease because of the reduction of charge passages due to bioclogging. However, the imaginary conductivity significantly increases with time, and clear bell-shaped relaxation behaviors are observed with the peak frequency of 0.1–1 Hz, associated with the double-layer polarization of cells and electrically conductive pili and biofilms. The Cole-Cole relaxation model appears to capture such relaxation behaviors well, and the modeling results indicate gradual increases in normalized chargeability and decreases in relaxation time during bacterial growth and biofilm formation in the highly saline condition. Comparison with previous literature confirms that the high-salinity condition further increases the normalized chargeability, whereas it suppresses the phase shift and thus the imaginary conductivity. Our results suggest that the complex conductivity can effectively capture microbial biomass formation in sands under a highly saline condition.
1 June 2025 in Géotechnique Letters
This study explores the effect of suppressed surface charges on the sedimentation behaviour and fabric of kaolinite clay. In particular, sedimentation behaviours were compared between negatively charged natural kaolin clays and surface-treated and hence electrically suppressed kaolin clays by methylene blue adsorption. The results clearly indicate that the negative surface charge impeded the sedimentation rate of kaolin by resisting particle aggregation. Such an effect appeared the most significant when the surrounding pH was less than the isoelectric point (IEP) of the mineral edges. Under a pH less than IEP, the flocculation time and the final void ratio remarkably dropped after the negative charge neutralisation. This was also corroborated by the scanning electron microscopy images, which further revealed the fabric transition from an edge-to-face flocculated structure to a face-to-face aggregated structure due to the absence of interparticle electrical forces. Conversely, there was no significant fabric change at pH higher than or near the IEP, even though the sedimentation behaviours were accelerated by forming larger flocs. This study imparts important insights into the fundamentals of microstructure and resulting sedimentation behaviour of clayey soils and how they can be changed in electrically neutralised clay.
24 October 2025 in Acta Geotechnica
Biofilm growth on grain surfaces and at pore throats can significantly reduce the hydraulic conductivity of soils. However, most studies on microbially induced soil clogging have been conducted under one-dimensional flow conditions, which often suffer from inlet clogging and deviate from radial flow conditions typically encountered in the field. This study presents an extensive compilation of published results, micromechanical analyses, pore-scale experiments, and macro-scale radial flow experiments. Results show that (1) the presence of bacteria has minimal impact on fluid viscosity, (2) biofilm growth on solid surfaces is constrained by flow velocity within pores, (3) bioclogging in coarse silts and fine sands can reduce hydraulic conductivity by two to three orders of magnitude, (4) bioclogging does not occur under high velocity flow in the near-field of the well, and (5) clogging develops at a characteristic radial distance determined by pore size and flow rate. The presented results provide insight into microbially induced bioclogging in porous media and a unique dataset to further develop novel bioclogging solutions for subsurface hydraulic conductivity barriers and seals.
16 July 2026 in Construction and Building Materials
26 September 2026 in SSRN Electronic Journal
Carbon mineralization in basaltic formations offers a secure pathway for geological carbon storage, yet its efficiency depends on fluid–rock interactions governing divalent cation release. This study investigates the long-term dissolution behavior of Cheorwon basalt (South Korea) under reservoir-relevant CO2 conditions using a two-stage design: an extended pre-injection equilibration phase, followed by CO2 injection at 10 MPa and 30°C, 60°C, and 80°C. Aqueous concentrations of Si, Ca, Mg, Al, and Fe were monitored over several months by ICP-OES. Silicon exhibited the most consistent apparent surface-normalized release rates (log r = -11.84 to -11.52), confirming its role as a reliable proxy for framework dissolution. Calcium and magnesium showed strongly non-stoichiometric release relative to Si, with Ca responding rapidly to CO2-induced acidification and Mg exhibiting slower, sustained mobilization. Iron and aluminum displayed transient concentration peaks followed by systematic aqueous depletion, with FE-SEM and FlatQuad EDS providing morphological and compositional evidence of secondary phase development on reacted grain surfaces. Apparent release rates are two to three orders of magnitude lower than strongly buffered acidic systems, underscoring the importance of pre-equilibration and long-duration experiments for reservoir-representative dissolution assessment.