1 October 2023 in Physics of Fluids
Bubbles adhering to the electrode surface are the major factors causing the decreased efficiency of water electrolysis. In this work, the dynamic behaviors of oxygen bubbles on vertical platinum sheet electrodes were investigated by a high-speed camera and their corresponding current densities were measured simultaneously using an electrochemical workstation. The impact of wide range of electrolyte pH values (i.e., 1–13) on both the bubble nucleation number and the dynamics behaviors of bubbles was investigated under different applied voltages. When the applied voltage was increased from 1.6 to 1.7 V vs the saturated calomel electrode, the radius of bubbles upon detachment increased in acidic environments (pH = 1–7) and decreased in alkaline environments (pH = 7–13). In an alkaline environment, the Marangoni force plays an essential role here. Furthermore, the bubble detachment radius predicted by the force balance model is well matched with our experimental results. Our results demonstrate that bubble detachment is not favorable in a strongly acidic environment, whereas oxygen bubbles exhibit rapid detachment from the electrode surface in a strongly alkaline environment.
1 January 2024 in Physics of Fluids
Understanding and controlling hydrogen bubble growth and detachment during water electrolysis is crucial for improving its efficiency. This study investigates bubble dynamics for hydrogen evolution on a platinum microelectrode in an acidic electrolyte with different gas/electrolyte surface tensions by adding varying surfactant concentrations. Three hydrogen bubble evolution patterns were observed: periodic detachment of individual bubbles at low surfactant concentrations of 0 and 1 × 10−7 M, respectively; one or two small bubbles are formed at the foot of the bubble during the evolution of single main bubble at intermediate surfactant concentrations of 1 × 10−6 and 1 × 10−5 M; and periodic detachment of large bubbles with aperiodic release of tiny bubbles at higher surfactant concentrations of 1 × 10−4 M. The concentration Marangoni force on individual H2 bubbles decreases significantly with surfactant concentration. This results in shorter evolution cycles from 138.12 to 6.98 s at −0.6 V vs the saturated calomel electrode, reduced detachment radii from 765.95 to 359.54 μm at −0.6 VSCE, and accelerated hydrogen bubble growth. This finding offers a new way to control bubble dynamics during electrochemical bubble formation.
1 July 2024 in Physics of Fluids
Enhancing the efficiency of hydrogen production by optimizing gas product transfer within water electrolysis systems is essential. Employing high-speed photography and electrochemical techniques, the entire process of single hydrogen bubble evolution on a Pt microelectrode surface was measured. Results reveal a notable reduction in both bubble detachment radius and growth time with decreasing absolute potential (from −7 to −3 V) and increasing reaction temperature (from 30 °C to 50 °C). Additionally, a comprehensive model estimating bubble coverage on the microelectrode is presented, incorporating bubble radius and current as key influencing factors. This enables an accurate evaluation of mass transfer coefficients during bubble evolution in the absence of forced flow. Furthermore, findings reveal the dominance of bubble-induced micro-convection as the primary mass-transfer mechanism for gas products at high current densities [O (105–106 A/m2)]. The results also indicate that the mass transfer coefficient increases during the inertia-controlled growth stage of bubbles and decreases during the stage controlled by chemical reactions.
1 July 2024 in Physics of Fluids
Bubbles generated during electrochemical water splitting could adhere to the electrode surface and therefore impede the reaction. Thus, understanding and manipulating the evolution dynamics of bubbles is crucial for enhancing electrolysis efficiency. In this study, we investigated the evolution mechanism and forces acting on individual hydrogen bubble on Pt microelectrode surface by employing different H2SO4 electrolyte concentrations (0.2–1.0 M) under various applied voltages [−2 to −6 V vs saturated calomel electrode (SCE)]. We focused on bubble detachment diameter, average current, and bubble lifetime and subsequently established relational equations over these variables. At −6 V vs SCE, the growth coefficient has a maximum value of 14.42 × 10−4 m/s0.333 when the concentration of electrolyte is around 0.6 M. Gas production at 0.6 M increased by 63.4% compared to 0.2 M and by 11.2% compared to 1.0 M. Therefore, choosing the appropriate electrolyte concentration can maximize gas production and bubble detachment efficiency. Additionally, a force balance model incorporating the Marangoni force for single bubbles on the microelectrode surface was established across varying concentrations of H2SO4 electrolyte. At −4 V vs SCE, the solutal Marangoni force starts to dominate when electrolyte concentrations above 0.4 M. The results demonstrate the critical role of the solutal Marangoni force beyond a certain value of electrolyte concentration.
6 August 2024 in The Journal of Chemical Physics
Regarding the rheological properties of fluids, certain nanoparticles can markedly modify the rheological behavior of low surface tension solutions by interacting with surfactant molecules. In this work, a low surface tension fluid with cetyltrimethylammonium chloride was prepared, and the silica nanoparticles were uniformly dispersed into it by ultrasonic dispersion. By adjusting the size, shape, and concentration of nanoparticles, the fluid behavior can be changed from Newtonian to non-Newtonian with finely tuned viscosity and characterized by a shear-thinning rheological behavior. In addition, this work explored how variations in environmental temperature and solution pH affect the rheological responses of the low surface tension suspension system. The experimental findings revealed that increasing the temperature substantially decreases the system’s viscosity and induces a shear-thickening behavior. It is particularly significant that, under extreme pH conditions (either strongly acidic or alkaline), the viscosity of the nanoparticle suspensions was markedly enhanced at a particle concentration of 10 000 ppm. This interesting result coincided with a notable reduction in the zeta potential and an increase in the average particle size, suggesting an intensified aggregation of particles within the suspension system. A mechanism detailing the interaction between silica nanoparticles and surfactant micelles was proposed. This work indicates that the incorporation of nanoparticles into surfactant solutions offers a powerful approach to modulating fluid rheology across various conditions.
14 February 2026 in International Journal of Green Energy