Department of Applied Sciences (Nanotechnology), Centre for Post-Graduate Studies, Visvesvaraya Technological University, Muddenahalli, Karnataka 562101, India
Auto-generated profile, based on publicly available information
Kunal Roy
Department of Applied Sciences (Nanotechnology), Centre for Post-Graduate Studies, Visvesvaraya Technological University, Muddenahalli, Karnataka 562101, India
In present study, the synthesis of spinel MnFe2O4 nanoparticles using a facile one-pot super critical fluid method and their application for Mg-ion battery application as anode materials is reported. The synthesized MnFe2O4 nanoparticles were well characterized for their structure and morphology using XRD, SEM, TEM and EDS analysis. The average particle size of materials was less than 50 nm with spinel structure. The main feature of magnesium ion battery is its high specific capacity and large volumetric energy density, which makes it a promising alternative to Li-ion batteries. The spinel MnFe2O4 material has been used as an anode material for Mg-ion batteries. At different C-rates (0.05C to 2C), electrochemical charge-discharge behaviour has been observed. In first cycle of the phase-pure spinel structured anode, an initial specific capacity of 195.82 mAh/g, 139.70 mAh/g, 25.04 mAh/g and 14.16 mAh/g were obtained at C rate of 0.05C, 0.1C, 1C and 2C, respectively. A possible phase conversion reaction of the anode resulted in a decrease in specific capacity with increasing C-rate.
Lithium-sulfur (Li-S) batteries has gained a lot of attention because of its high energy density (2567 Whkg−1), great earth abundance, and low impact on the environment. The excellent theoretical performance of Li-S batteries is compromised by major technical challenges like low sulfur utilization rate, reduced columbic efficiency, and poor cycling stability due to the insulating nature of sulfur and the shuttle effect of soluble lithium polysulfides. To overcome these concerns, herewith, made an attempt to synthesise Sulfur -reduced graphene oxide (S-RGO) nanocomposite by rapid fast heating technique. Using the solution-based rapid heating method, sulfur nanoparticles uniformly distributed on graphene oxide network. Furher, deployed in fabricating Li-S cathode. The S-RGO composite with 80 wt% sulfur exhibits promising results. Initially, at 0.05 C rate discharge current shows 1230 mAh/g capacity and at 0.1 C rate shows 1085 mAh/g. After 50 cycles, the capacity was retained with 1030 mAh/g at 0.05C and 957 mAh/g at 0.1C. This suggests that the the synthesised Li-S nanocomposite exhibit good capacity at higher current rate with greater sulfur content. Expression of concern (20 January 2026). This article is currently under investigation following an allegation that raises concerns over the citations and originality of the work. As a member of COPE this is being investigated in accordance with the COPE guidelines, and as such an expression of concern is applied.