10 November 2023 in Measurement Science and Technology
Through the analysis of data from the SCADA system of a wind turbine unit in a specific offshore wind farm located in Zhanjiang, it was observed that the most prevalent type of fault is bearing alarms on the gearbox’s generator side. Considering the growing need for intelligent offshore wind turbine maintenance, this study employed GRA on SCADA data collected over a significant duration from a representative wind turbine unit. Relevant features were extracted, with temperature serving as the target parameter. To address the challenge of long-term dependencies in long-term time series forecasting tasks, this study uniquely combined the GRU with the advanced Transformer neural network which incorporates attention mechanisms, to predict the temperature trend of the gearbox’s generator-side bearing. Based on the prediction residuals obtained during normal operation and their subsequent analysis, the study devised an effective anomaly detection process to identify early abnormal states of the gearbox’s generator-side bearing. Comparative performance evaluations were conducted, comparing the combined model with its individual component models, as well as the traditional LightGBM, in terms of temperature time series prediction and their application in anomaly detection. The results unequivocally demonstrate that the combined model outperforms both the individual models and LightGBM in terms of time series prediction accuracy and anomaly detection effectiveness, indicating an enhanced ability to handle long-term memory challenges. Furthermore, the combined model exhibits great potential of practical application for the early warning of gearbox bearing anomalies during actual wind turbine daily operation and maintenance, providing a valuable solution for the offshore wind turbine industry.
10 April 2024 in Measurement Science and Technology
The supervisory control and data acquisition (SCADA) system of wind turbines continuously collects a large amount of monitoring data during their operation. These data contain abundant information about the operating status of the turbine components. Utilizing this information makes it feasible to provide early warnings and predict the health status of the wind turbine. However, due to the strong coupling between the various components of the wind turbine, the data exhibits complex spatiotemporal relationships, multiple state parameters, strong non-linearity, and noise interference, which brings great difficulty to anomaly detection of the wind turbine. This paper proposes a new method for detecting abnormal operating conditions of wind turbines, based on a cleverly designed multi-layer linear residual module and the improved temporal convolutional network (TCN) with a new norm-linear-ConvNeXt architecture (NLC-TCN). Initially, the NLC-TCN deep learning reconstruction model is trained with historical data of normal behavior to extract the spatiotemporal features of state parameters under normal operational conditions. Subsequently, the condition score of the unit is determined by calculating the average normalized root mean square error between the reconstructed data and actual data. The streaming peaks-over-threshold real-time calculation of the anomaly warning threshold, based on extreme value theory, is then used for preliminary fault monitoring. Moreover, by shielding the fault alarm for low wind speeds and implementing a continuous delay perception mechanism, issues related to wind speed fluctuations and internal and external interference are addressed, enabling early warning for faulty units. Finally, the effectiveness and reliability of the proposed method are validated through comparative experiments using actual offshore wind farm SCADA data. The performance of the proposed method surpasses that of other compared methods. Additionally, the results of the proposed method were evaluated using the uniform manifold approximation and projection dimensionality reduction technique and kernel density estimation.