12 November 2021 in Science Advances
Membrane-based heterostructure, verified experimentally and theoretically, opens possibiliies for low-power magnetoelectrics.
15 November 2021 in Applied Physics Letters
Bulk single-crystal relaxor-ferroelectrics, like Pb(Mg1/3Nb2/3)O3-PbTiO3 (PMN-PT), are widely known for their large piezoelectricity. This is attributed to polarization rotation, which is facilitated by the presence of various crystal symmetries for compositions near a morphotropic phase boundary. Relaxor-ferroelectric thin films, which are necessary for low-voltage applications, suffer a reduction in their piezoelectric response due to clamping by the passive substrate. To understand the microscopic behavior of this adverse phenomenon, we employ the AC electric field driven in-operando synchrotron x-ray diffraction on patterned device structures to investigate the piezoelectric domain behavior under an electric field for both a clamped (001) PMN-PT thin film on Si and a (001) PMN-PT membrane released from its substrate. In the clamped film, the substrate inhibits the field-induced rhombohedral (R) to tetragonal (T) phase transition resulting in a reversible R to Monoclinic (M) transition with a reduced longitudinal piezoelectric coefficient d33 < 100 pm/V. Releasing the film from the substrate results in recovery of the R to T transition and results in a d33 > 1000 pm/V. Using diffraction with spatial mapping, we find that lateral constraints imposed by the boundary between the active and inactive materials also inhibit the R to T transition. Phase-field calculations on both clamped and released PMN-PT thin films simulate our experimental findings. Resolving the suppression of thin film piezoelectric response is critical to their application in piezo-driven technologies.
7 November 2016 in Applied Physics Letters
Reversible control over the electrical properties of the two-dimensional electron gas (2DEG) in oxide heterostructures is a key capability enabling practical applications. Herein, we report an efficient method to reversibly tune the charge carrier density of the 2DEG by surface modification. We demonstrate both increasing and decreasing the carrier density of the LaAlO3/SrTiO3 2DEG interface via application of functional phosphonic acids with molecular dipoles pointing either toward or away from the interface, respectively. In addition, in the case of the enhanced 2DEG, we recovered the initial conduction properties by exposing the samples to a basic solution. The tuning processes were highly reversible over repetitive cycles. These results reveal that the surface modification is an efficient way to tune the carrier density of 2DEG in oxide heterostructures. This simple chemical approach offers a vast range of fabrication possibilities in versatile electronic device applications.