Qizhou Gong

Qizhou Gong

Auto-generated profile, based on publicly available information

Qizhou Gong

State Key Laboratory of Deep Earth Exploration and Imaging and the College of Instrumentation and Electrical Engineering Department, Jilin University, Changchun, China

Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
27 December 2023 in Expert Systems with Applications
Verified
Journal Article
Closed access
MWMaofa Wang
Maofa Wang
QGQizhou Gong
Qizhou Gong
QWQuan Wan
Quan Wan
ZLZhixiong Leng
Zhixiong Leng
YXYanlin Xu
Yanlin Xu
SSShaohua Sun
Shaohua Sun

14 February 2025 in IEEE Transactions on Instrumentation and Measurement
Verified
Journal Article
Closed access
YZYue Zhang
Yue Zhang
YWYanzhang Wang
Yanzhang Wang
QXQuan Xu
Quan Xu
QGQizhou Gong
Qizhou Gong
ZLZhaowen Liu
Zhaowen Liu
SWShilong Wang
Shilong Wang
Due to the increasing demand for mineral resources, mineral exploration is advancing toward difficult terrain areas. When a helicopter transient electromagnetic (HTEM) system is operating in complex terrain areas, severe-induced voltage noise occurs in the early signals, which affects shallow detection. Through analysis, we found that this noise essentially comes from the slight variation in the relative position between the receiving coil and the transmitting coil, resulting in a change in mutual inductance between the two. This change causes the primary transient electromagnetic (TEM) field to change constantly and affects observations of the secondary TEM field. Frequency amplitude analysis of actual early signals shows that the noise frequency can reach 0.06 Hz, which is lower than the 25-Hz excitation frequency. Therefore, based on the assumption that the mutual inductance remains constant within each half-cycle of excitation, this article proposes a method to suppress early signal noise by calculating the regression coefficient vector of high-altitude data. This method only uses induced voltage data to suppress noise and has a short processing time. Actual exploration line results verify that the peak value of the earliest gate signal decreases from 1856.9 to 155.12 nT/s, with an early observation time of $104.67 \; \mu $ s.

20 May 2024 in IEEE Transactions on Instrumentation and Measurement
Verified
Journal Article
Closed access
QXQuan Xu
Quan Xu
YWYanzhang Wang
Yanzhang Wang
YZYue Zhang
Yue Zhang
ZLZhaowen Liu
Zhaowen Liu
HLHua Li
Hua Li
SWShilong Wang
Shilong Wang
The bird’s movement causes a variable primary response in the helicopter transient electromagnetic (HTEM) system called primary multiplicative noise (PMN). PMN dominates measured data on time and early off time and will significantly impede the interpretation of shallow earth. Measuring and estimating PMN is difficult due to the complexity of the kinematic state and the high testing cost. We propose to use the elastic-net regularized linear regression (ENLR) framework to suppress PMN and adaptive momentum estimation (Adam) to speed up the process. First, we analyze the generation mechanism and time-frequency domain characteristics of PMN. Second, we built the ENLR framework and designed the loss function based on the attributes of PMN and signals. Then, we employ Adam to solve the loss function and obtain the estimated PMN of all half periods. Finally, the PMN is subtracted from the original signal. Field tests show that the proposed method effectively removes the PMN, advances the earliest time gate that meets the error requirement from 255.21 μs to 20.83 μs after the first time gate, and improves the system’s ability to detect anomalies as shallow as 20 m.

26 November 2025 in IEEE Journal of Emerging and Selected Topics in Power Electronics
Verified
Journal Article
Closed access
YZYue Zhang
Yue Zhang
YWYanzhang Wang
Yanzhang Wang
QGQizhou Gong
Qizhou Gong
YSYifei Shao
Yifei Shao
MJMenghao Jia
Menghao Jia
SWShilong Wang
Shilong Wang
Helicopter Transient Electromagnetic (HTEM) instrument systems now require dual-waveform (high/low-energy) current inverters for single-flight shallow/deep detection in complex terrains. Low-energy waveforms require earlier observation windows and stronger excitation to enhance shallow-resolution, but current designs using fixed clamping voltage and long current tails limit shallow data acquisition. This paper proposes a dual-clamping coordinated dual-waveform current inverter. A series-type fast on-off module, without compromising high-energy performance, increases the low-energy waveform clamping voltage from 450V to 720V or higher, amplifying electromagnetic excitation. By modeling parasitic capacitance, damping resistors are optimally selected to eliminate turn-off oscillations. Through damping optimization via extended high-voltage clamping duration, the current tail decay time was shortened from 23.1μs to 10.6μs. Results from forward modeling in complex terrains demonstrate that the proposed current inverter achieved a 2.86-fold increase in the response amplitude variation of the earliest time gate. The dual-clamping current inverter presents an innovative dual-waveform design, significantly enhancing shallow detection performance and providing a practical framework for advancing HTEM applications.

19 May 2026 in IEEE Geoscience and Remote Sensing Letters
Verified
Journal Article
Closed access
YSYifei Shao
Yifei Shao
QGQizhou Gong
Qizhou Gong
YZYue Zhang
Yue Zhang
CSCaitang Sun
Caitang Sun
SWShilong Wang
Shilong Wang
QXQuan Xu
Quan Xu
Helicopter transient electromagnetic (HTEM) method exhibits significant advantages in geological exploration of complex terrain areas, yet its data inversion still faces challenges such as low computational efficiency and poor inversion accuracy. Aiming at the problems of poor continuity of 1D inversion and high computational cost of 3D inversion, this letter proposes a 2.5D HTEM inversion method based on the SE-TransUNet network. This method performs forward modeling on the subsurface resistivity model with infinite horizontal extension using a 3D source to generate a dataset, and uses an improved TransUNet architecture for inversion. The SE-TransUNet network combines the Squeeze-and-Excitation (SE) module and Transformer blocks on the basis of U-Net neural network to enhance feature extraction and long-range dependency modeling, thereby improving the ability to reconstruct subsurface resistivity models. In experiments with synthetic and field data, compared with the Gauss-Newton method and the U-Net method, SE-TransUNet achieved better performance in the characterization of anomalous body boundaries, localization of anomalous bodies, and overall inversion accuracy, with an inversion time of only 5 seconds. The results verify the reliability and high efficiency of the proposed method for high-resolution HTEM inversion in practical geological exploration, providing an effective solution for fast and reliable HTEM inversion.