Interest and investment in electric vertical takeoff and landing aircraft (VTOLs), commonly known as flying cars, have grown significantly. However, their sustainability implications are unclear. We report a physics-based analysis of primary energy and greenhouse gas (GHG) emissions of VTOLs vs. ground-based cars. Tilt-rotor/duct/wing VTOLs are efficient when cruising but consume substantial energy for takeoff and climb; hence, their burdens depend critically on trip distance. For our base case, traveling 100 km (point-to-point) with one pilot in a VTOL results in well-to-wing/wheel GHG emissions that are 35% lower but 28% higher than a one-occupant internal combustion engine vehicle (ICEV) and battery electric vehicle (BEV), respectively. Comparing fully loaded VTOLs (three passengers) with ground-based cars with an average occupancy of 1.54, VTOL GHG emissions per passenger-kilometer are 52% lower than ICEVs and 6% lower than BEVs. VTOLs offer fast, predictable transportation and could have a niche role in sustainable mobility.
15 February 2018 in Environmental Science & Technology
Responsible disposal of vehicles at the end of life is a pressing environmental concern. In particular, waste plastic forms the largest proportion of non-recycled waste material from light-duty vehicles, and often ends up in a landfill. Here we report the upcycling of depolluted, dismantled and shredded end-of-life waste plastic into flash graphene using flash Joule heating. The synthetic process requires no separation or sorting of plastics and uses no solvents or water. We demonstrate the practical value of the graphene as a re-inforcing agent in automotive polyurethane foam composite, where its introduction leads to improved tensile strength and low frequency noise absorption properties. We demonstrate process continuity by upcycling the resulting foam composite back into equal-quality flash graphene. A prospective cradle-to-gate life cycle assessment suggests that our method may afford lower cumulative energy demand and water use, and a decrease in global warming potential compared to traditional graphene synthesis methods.
23 July 2019 in Environmental Science & Technology
Electrification and lightweighting technologies are important components of greenhouse gas (GHG) emission reduction strategies for light-duty vehicles. Assessments of GHG emissions from light-duty vehicles should take a cradle-to-grave lifecycle perspective and capture important regional effects. We report the first regionally explicit (county-level) lifecycle assessment of the use of lightweighting and electrification for light-duty vehicles in the U.S. Regional differences in climate, electric grid burdens, and driving patterns compound to produce significant regional heterogeneity in the GHG benefits of electrification. We show that lightweighting further accentuates these regional differences. In fact, for the mid-sized cars considered in our analysis, model results suggest that aluminum lightweight vehicles with a combustion engine would have similar emissions to hybrid electric vehicles (HEVs) in about 25% of the counties in the US and lower than battery electric vehicles (BEVs) in 20% of counties. The results highlight the need for a portfolio of fuel efficient offerings to recognize the heterogeneity of regional climate, electric grid burdens, and driving patterns.
1 January 2021 in Resources, Conservation and Recycling