Feiyang Zhao

Feiyang Zhao

Auto-generated profile, based on publicly available information

Feiyang Zhao

Department of Mechanical Engineering, National University of Singapore, Singapore, Singapore

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
2 August 2019 in International Journal of Green Energy
Verified
Journal Article
Closed access
WYWenbin Yu
Wenbin Yu
FZFeiyang Zhao
Feiyang Zhao
Many degrees of freedom on engine operating parameters limit the optimizing of engine managements for the sake of simultaneously complying with emission regulations and energy economy requirements. Adaptive neuro-fuzzy inference system (ANFIS) is the combination of neural network and fuzzy logic, able to solve nonlinear problems those do not have algorithmic solutions and cannot be modeled mathematically, thus eliminating the limitations of classical approaches. In this study, ANFIS was employed to map the relationships between controlled boundaries and engine performances. A total number of 80 experimental data on dual-fuel diesel engine were selected for training and testing the ANFIS model which has six input variables (diesel fuel injection timing, gasoline premixed ratio, rate of exhaust gas recirculation, indicated mean effective pressure, and the timings of 10% and 50% of total heat release) within a wide validity ranges of engine operating parameters and four outputs of engine emissions and performance. Then, the ANFIS outputs were used to evaluate the objective functions of the optimization process, which was performed with a genetic algorithms (GA) multi-objective optimizing approach. Finally, the Pareto-optimal sets were plotted with minimized NOx as well as soot emissions within the imposed constraints of pressure rise rate and efficiency. This paper studied the feasibility of using ANFIS in combination with GA to optimize the diesel engine settings so that the optimal engine performance and emission behavior would be obtained. The characteristics of the optimal solutions were ultimately explored by sensitivity analysis.


10 July 2019 in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
Verified
Journal Article
Closed access
WYWenbin Yu
Wenbin Yu
FZFeiyang Zhao
Feiyang Zhao
Biodiesels are considered as promising fuels to substitute diesel fuel which can fill the gap of energy shortage while maintaining the diesel engine’s efficiency. Variations in the properties of different biodiesel fuels are caused by the varied fatty acid methyl esters (FAMEs) compositions derived from their parent oils. Therefore, correlating key properties such as cetane number (CN), kinematic viscosity (KV), iodine value (IV) and cold filter plugging point (CFPP) with FAMEs compositions of each biodiesel fuel is significant to developing whatever new types of fuels applied on diesel engines. In this study, an intelligent genetic algorithm (GA)-based back propagation neural network (BPNN) model was proposed to predict the properties of biodiesel fuels according to FAMEs compositions. The hybrid BPNN-GA model has five inputs (methyl palmitate, methyl stearate, methyl oleate, methyl linoleate and methyl linolenate) corresponding to the FAMEs compositions and outputs with estimated fuel properties, with the GA assisting on training to find out local minimum deviation and updated weighting configurations. It was found that the intelligent learning-training method proposed hybrid BPNN-GA model enabled to map the non-linear relationships between the FAMEs compositions and key properties of biodiesel fuels with fairly good agreement. The predicted value of fuel properties agrees with measured ones with R-square up to 96%, along with lower value (less than 10%) over Root Mean Square Error (RMSE) and Mean Absolute Percentage Error (MAPE) than those of other empirical correlations. In addition, a sensitivity analysis was conducted to in-depth investigate the FAMEs compositions on key properties. It was concluded that saturated FAMEs have positive impacts on CN, KV and the CFPP, while IV is typically dependent on unsaturated FAMEs. Therefore, it is attainable to formulate new types of alternative fuels based on the required properties on diesel engine applications.

8 April 2019 in Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering
Verified
Journal Article
Closed access
PDF file
KTKun Lin Tay
Kun Lin Tay
Wenbin YuWenbin Yu
Wenbin Yu
FZFeiyang Zhao
Feiyang Zhao
Wenming YangWenming Yang
Wenming Yang
The use of kerosene in direct injection compression ignition engines is fundamentally due to the introduction of the Single Fuel Concept. As conventional direct injection compression ignition diesel engines are made specifically to use diesel fuel, the usage of kerosene will affect engine emissions and performance due to differences between the fuel properties of kerosene and diesel. As a result, in order for kerosene to be properly and efficiently used in diesel engines, it is needful for the scientific community to know the properties of kerosene, its autoignition and combustion characteristics, as well as its emissions formation behavior under diesel engine operating conditions. Moreover, it is desirable to know the progress made in the development of suitable kerosene surrogates for engine applications as it is a crucial step toward the development of reliable chemical reaction mechanisms for numerical simulations. Therefore, in this work, a comprehensive review is carried out systematically to better understand the characteristics and behavior of kerosene under direct injection compression ignition engine relevant conditions. In this review work, the fuel properties of kerosene are summarized and discussed. In addition, fundamental autoignition studies of kerosene in shock tube, rapid compression machine, fuel ignition tester, ignition quality tester, constant volume combustion chamber, and engine are compiled and evaluated. Furthermore, experimental studies of kerosene spray and combustion in constant volume combustion chambers are examined. Also, the experimental investigations of kerosene combustion and emissions in direct injection compression ignition engines are discussed. Moreover, the development of kerosene surrogates, their chemical reaction mechanisms, and the modeling of kerosene combustion in direct injection compression ignition engines are summarized and talked about. Finally, recommendations are also given to help researchers focus on the areas which are still severely lacking.