27 February 2012 in Physical Review Letters
A heated semiconductor light-emitting diode at low forward bias voltage V<kBT/q is shown to use electrical work to pump heat from the lattice to the photon field. Here the rates of both radiative and nonradiative recombination have contributions at linear order in V. As a result the device's wall-plug (i.e., power conversion) efficiency is inversely proportional to its output power and diverges as V approaches zero. Experiments directly confirm for the first time that this behavior continues beyond the conventional limit of unity electrical-to-optical power conversion efficiency.
6 April 2018 in Physical Review B
We calculate linear and nonlinear optical susceptibilities arising from the excitonic states of monolayer for in-plane light polarizations, using second-quantized bound and unbound exciton operators. Optical selection rules are critical for obtaining the susceptibilities. We derive the valley-chirality rule for the second-order harmonic generation in monolayer and find that the third-order harmonic process is efficient only for linearly polarized input light while the third-order two-photon process (optical Kerr effect) is efficient for circularly polarized light using a higher order exciton state. The absence of linear absorption due to the band gap and the unusually strong two-photon third-order nonlinearity make the monolayer excitonic structure a promising resource for coherent nonlinear photonics.
25 August 2020 in Physical Review Applied
We demonstrate voltage-tunable thermo-optic bi- and tristability in silicon photonic microring resonators with lateral -- junctions and present a technique for characterizing the thermo-optic transient response of integrated optical resonators. Our method for thermo-optic transient response measurement is applicable to any integrated photonics platform and uses standard equipment. Thermo-optic relaxation in encapsulated waveguides is found to be approximately logarithmic in time, consistent with the analytical solution for two-dimensional heat diffusion. We develop a model for thermo-optic microring multistability and dynamics that agrees with experimental data over a wide range of operating conditions. Our work highlights the fundamental connection in semiconductor waveguides between active free-carrier removal and thermo-optic heating, a result of particular relevance to Kerr soliton-state stability and on-chip frequency-comb generation. The devices studied here are fabricated in a CMOS foundry process and as a result our model is useful for the design of silicon photonic waveguide devices.
3 May 2018 in Journal of Lightwave Technology
We model optical parametric oscillation in ring cavities with two-photon absorption, focusing on silicon at 1.55μm. Oscillation is possible if free-carrier absorption can be mitigated; this can be achieved using carrier sweep-out in a reverse-biased p-i-n junction to reduce the carrier lifetime. By varying the pump power, detuning, and reverse-bias voltage, it is possible to generate frequency combs in cavities with both normal and anomalous dispersion at a wide range of wavelengths including 1.55μm. Furthermore, a free-carrier self-pulsing instability leads to rich dynamics when the carrier lifetime is sufficiently long.
17 September 2018 in Physical Review Materials
We report on a laser annealing procedure which greatly improves the quality of suspended monolayers of chemical vapor deposition grown . Annealing with a green laser locally heats the suspended flake to approximately 600 K, which both removes contaminants and reduces strain gradients. At 4 K, we observe linewidths as narrow as 3.5 meV (1.6 nm) full width at half maximum for both photoluminescence and reflection. Large peak reflectances up to 47% are also observed. These values are comparable to those of the highest quality hexagonal boron nitride encapsulated samples. We demonstrate that this laser annealing process can yield highly spatially homogeneous samples, with the length scale of the homogeneity limited primarily by the size of the suspended area. Annealed regions are very stable, exhibiting negligible deterioration over 24 h at cryogenic temperatures. The annealing method is also very repeatable, with substantial improvements of sample quality on every spot () tested.