24 February 2009 in Journal of Intelligent Manufacturing
28 October 2014 in The International Journal of Advanced Manufacturing Technology
20 December 2016 in Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science
The main purpose of this study is to investigate the effect of sheet thickness on nugget size and residual stresses in resistance spot welding. A two-dimensional coupled electro-thermo-mechanical finite element model is employed to predict the residual stresses in aluminum alloy 6061-T6. The simulation results are compared with the results obtained from the experimental nugget size and the residual stresses are measured by the X-ray diffraction method. The results indicate that the highest tensile residual stress occurs at the center of the nugget and diminish along the nugget radius. The residual stresses increase on increasing the electrical current and reducing the welding time. By increasing the sheet thickness, the affordable range of welding current and welding cycle increase. It also leads to the enlargement of the nugget, which consequently results in the increase of the residual stresses.
16 February 2012 in Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture
The aim of this article is to predict the failure load in resistance spot welded aluminum 6061-T6 sheets with 2 mm thickness under quasi-static tensile test. Various welding parameters, e.g. welding current, welding time and electrode force are selected to produce welded joints with different quality. The results show that for all the samples in this study only interfacial failure mode was observed in tensile-shear test and no pull-out mode was observed. According to the failure mode, an empirical equation was used for the prediction of failure load based on nugget size and hardness of failure line. Microstructure study has been carried out to investigate microstructural changes in the welded joints. For determination of the minimum hardness, microhardness tests have been carried out to find hardness profiles. The minimum hardness value was observed for a thin layer around the nugget with large and coarse grains. The results show that by using the presented empirical equation, the failure can be predicted with a good agreement only by measuring nugget size.
30 July 2013 in Journal of Materials Engineering and Performance
4 July 2016 in Aircraft Engineering and Aerospace Technology
The purpose of this paper is to predict residual stresses in resistance spot weld of 2 mm thick aluminum 6061-T6 sheets. The joint use of finite element analysis and artificial neural networks can eliminate the high costs of residual stresses measuring tests and significantly shorten the time it takes to arrive at a solution. Finite element method and artificial neural network have been used to predict the residual stresses. Different spot welding parameters such as the welding current, the welding time and the electrode force have been used for the simulation purposes in a thermal-electrical-structural coupled finite element model. To validate the numerical results, a series of experiments have been performed, and residual stresses have been measured. The results obtained from the finite element analysis have been used to build up a back-propagation artificial neural network model for residual stresses prediction. The results revealed that the neural network model created in this study can accurately predict residual stresses produced in resistance spot weld. Using a combination of these two developed models, the residual stresses can be predicted in terms of spot weld parameters with high speed and accuracy. The paper includes implication for aircraft and automobile industries to predict residual stresses. Residual stresses can lower the strength and fatigue life of the spot-welded joints and determine the performance quality of the structure. This paper presents an approach to reduce the high costs and long times of residual stresses measuring tests.