30 November 2023 in Journal of Optical Communications and Networking
A joint channel coded modulation scheme based on symbol division multiplexing (SDM) is proposed and experimentally demonstrated in a 100-Gb/s discrete multi-tone wavelength division multiplexing passive optical network (DMT-WDM-PON) with enhanced symbol capacity and system power loss budget. The SDM was performed through low-density parity check (LDPC) coded quadrature amplitude modulation (QAM) following the optimized many-to-one mapping rule. By time domain multiplexing all four 6-bit/symbol 64QAM symbols together onto the same complex constellation point, the produced SDM-16QAM can achieve a 50% symbol capacity gain compared to the typical 16QAM with the same symbol rate. For low-latency intention, the fifth-generation new radio standard LDPC code with ultra-short code length and flexible code rate is structured to provide high signal transmission reliability and a robust mechanism within both intra- and inter-SDM symbols, supporting the iterative SDM de-multiplexing. The SDM significantly reduces the QAM orders and widens the constellation Euclidean distance, which can optimize the signal launch fiber power and reduce the resolution requirements for optoelectronic and electronic components, thus leading to apparent enhancement of the power loss budget to serve more optical network units. The experimental results show that a 4.11-dB power loss budget gain can be achieved including 1.25-dB superior receiver power sensitivity and 2.86-dB improvement of launch fiber power in the proposed DMT-WDM-PON over 20-km fiber transmission.
18 December 2023 in Journal of Lightwave Technology
This paper proposes a method for synthesizing a multiple sideband superposed 32QAM (MSBS-32QAM) signal from a QPSK and an 8QAM using a dual drive Mach-Zehnder modulator (DD-MZM) via intensity modulation/direct detection (IM/DD). This technique doubles the electrical spectral efficiency (SE) compared to DD-MZM-based single sideband (SSB) modulation because the two sidebands carry different data. Such ability to carry two different sidebands doubles the SE compared to the typical double sideband (DSB) modulation while realizing the recovery of complex DSB signal via IM/DD. Digital signal processing (DSP) is used to separate and demodulate the QPSK and 8QAM signal from the MSBS-32QAM signal, saving the optical filters/polarizers/interleaves used in the twin-SSB scheme, thus reducing receiver complexity and cost.
16 June 2025 in Optics Express
Overcoming the capacity bottleneck of single-mode fiber (SMF), we exploit the exceptionally low-loss and low-nonlinearity characteristics of hollow-core fiber (HCF) to demonstrate a 198-channel × 40 Gbaud polarization multiplexed 256QAM (PM-256QAM) WDM system over a 20.6 km nested anti-resonant nodeless fiber (NANF) transmission link. A hardware-efficient, low-complexity carrier recovery algorithm is employed, relying entirely on polarized misaligned pilot symbols for robust frame synchronization and high-precision carrier recovery, eliminating the need for training sequences. Compared to conventional methods constrained by fourth-power operations and pilot symbol intervals, our approach offers a wider frequency offset estimation (FOE) range and enhanced carrier phase recovery (CPR). Experimental results demonstrate that the bit error rate (BER) of all 198 WDM channels remains below the 20% soft-decision forward error correction (SD-FEC) threshold, achieving spectral efficiencies of 12.8 bit/s/Hz in the C-band and 13.1 bit/s/Hz in the L-band. Benefiting from the unique properties of HCF, the system demonstrates superior performance compared to conventional single-mode fiber, particularly at high launch powers. This work paves the way for future ultra-high-capacity, low-latency optical networks, providing a viable technological path for next-generation communication systems.
10 July 2025 in Journal of Lightwave Technology
The inter-symbol-interference (ISI) is the major impairment in bandwidth-efficient intensity modulation and direct detection (IM/DD) interconnection systems regarding simultaneous low power consumption and high cost-effectiveness. The ISI can be well compensated by advanced digital equalizer cooperated with maximum likelihood sequence estimation (MLSE), and look-up table (LUT) associated MLSE schemes. However, under severe ISI scenarios, the implementation complexity of the combined LUT and MLSE increases significantly as the memory length for the required LUT expands. In this paper, an MLSE scheme employing pattern-integrated LUT (PiLUT-MLSE) with a reduced stage profile is proposed and demonstrated in a bandwidth-efficient 4-level pulse amplitude modulation (PAM-4) IM/DD interconnection system. The intermediate symbols are shared in integrated patterns by simply counting the ISI between adjacent preceding and succeeding symbols to optimize the LUT size effectively. By doing so, the computational loads for subsequent MLSE path comparison and addition are significantly reduced with the assistance of the optimized PiLUT. The effectiveness of the proposed PiLUT-MLSE is validated using 112, 140, and 160 Gbit/s PAM-4 signals transmitted over distances of 2 km, 1 km, and 500 m standard single-mode fiber (SSMF), in a 3 dB bandwidth of 19 GHz. Experimental results performed in 112/140 Gbit/s PAM-4 system indicate that the PiLUT-MLSE significantly decreases the ISI impairments with 0.8/1-dB receiver power sensitivity improvement, compared with typical linear MLSE scheme at the 7% hard-decision forward error correction threshold of 3.8e-3. In addition, the proposed scheme can support the transmission of 160 Gbit/s PAM-4 signal at the bit error rate below 3.8e-3. Furthermore, the results show that even in an ultra-high bandwidth efficient system and accounting for the optimal computational complexity approach, the proposed scheme can reduce the LUT size by 75% as compared with a conventional one, thus that dynamic branch metric of MLSE equalizer can be further optimized in terms of multiplications by 100%, additions by 75% and comparator by 75%, with only a 0.1∼0.4 dB penalty in received optical power.
9 June 2025 in Optics Express
To fully address the inter-symbol interference (ISI) for ultra-high bandwidth efficiency (BE) application, a hybrid integrated forward error correction (FEC) equalization (IFE) scheme is proposed and experimentally demonstrated in a coherent optical interconnection system. The estimation for the channel response affected with severe ISI is realized by an adaptive linear minimum mean square error (LMMSE) equalizer, assisted with soft-input soft-output (SISO) a posteriori information by low density parity check (LDPC) decoder, allowing simultaneously accurate ISI deduction and reliable FEC decoding. The proof-of-concept experiments are investigated in a 60 GBaud polarization division multiplexed 16 quadrature amplitude modulation system within a 5-GHz ultra-narrow bandwidth receiver. The results show that the proposed IFE scheme successfully obtains more than 3-dB optical signal-to-noise ratio (OSNR) gain compared with the serial, independent structure of the equalizer and the FEC decoder at the BER threshold of 1??10?2. The validity comparison of ISI reduction ability between traditional soft-decision maximum likelihood sequence estimation (MLSE) and the proposed IFE scheme has been experimentally investigated, with the proposed scheme demonstrating greater robustness.
2 June 2025 in Optics Express
To effectively mitigate the impairments of severe inter-symbol interference (ISI), a least-square-assisted Bahl, Cocke, Jelinek, and Raviv (LS-BCJR) detection algorithm is proposed and experimentally demonstrated in a bandwidth-limited intensity-modulation direct-detection (IM/DD) pulse amplitude modulation (PAM4) optical interconnection system. A training-based short-tap LS equalizer is utilized after the 1?+?D post filter to dynamically reconstruct an effective channel response, thus assisting the BCJR estimator to optimize the transition metric calculation and obtain more accurate probabilistic information from the Markov for soft-symbol decision. The experimental results reveal the enhanced system performance with the 160 Gb/s PAM4 signals transmitted within a 19-GHz system bandwidth. The proposed LS-BCJR scheme improves the received optical power sensitivity by 1.2 and 0.9 dB under the validity comparison of the maximum likelihood sequence estimation (MLSE) and conventional BCJR schemes at the BER threshold of 2.4e-2. Furthermore, the LS-BCJR achieves the optimal receiver sensitivity improvement by 3 dB at the BER threshold of 3.8e-3, demonstrating a notable improvement over the conventional BCJR scheme.